¾Select AUTOMATICALLY if neither of the special circumstances mentioned above fits your situation. When this option is selected, the screen changes to show automatic configuration options. Do the following:

a Select the Enable option button, then click Save Changes.

b The page changes to the Autodetect page and a Start button appears. Click the Start button to begin the automatic configuration. A message appears to let you know that the current configuration, if any, will be lost when the X4 configures itself. Click OK to dismiss this message.

c Wait while the X4 modem searches for the correct VPI, VCI, and Encapsulation settings and connects with your Internet service provider. This may take a few minutes because the modem must try various combinations until it finds the settings that match your service provider’s.

3 Once the modem detects your settings, your VPI, VCI, and Encapsulation settings will appear in the table on the Autodetect page. Click the Encapsulation setting to continue with the process.

When your Encapsulation setting appears, click it to continue with the process. (Note that yours may be something other than PPPoE.)

Note:

If your Encapsulation setting is not found (that is, if “No Encapsulation Protocol Detected” remains on the screen), select the Disable option button, click Save Changes, then click the Basic Setup icon at the top of the screen and try to manually configure the modem, as explained in Configuring the X4 Manually on page 16.

14

ADSL X4 User Guide