Important!

If you plan to use a static IP address, you must manually configure the X4 from the WAN Configuration page and not the Basic Setup page. For more information, see Using Static IP Addressing on page 19. Typically, you must make arrangements with (and pay) your Internet service provider for a static IP address.

5 In the VPI and VCI boxes, enter the settings for your service provider.

6 Click Save Changes and then Write Settings to Flash. Once the process is complete, the X4’s DSL light should remain on steady (this should take about 15 seconds).

7 Verify that your Internet connection is working. Open your Web browser and try to connect to a familiar Web address.

If you connect successfully, your installation is complete and you are ready to browse the Web!

Congratulations! You have completed all you need to do to get your computer on the Internet. The remainder of this user’s guide is for troubleshooting and for advanced users who need information about status monitoring and advanced setup options.

If You Did Not Connect

If you did not connect and you are using settings provided by your service provider, repeat steps 3–7 above and ensure that you enter the information correctly (especially your Username and Password, if your Encapsulation begins with PPP). If you still cannot connect, look up your provider in the ADSL Internet Settings Tables on page 41 and try the setting(s) shown, if different.

If you did not connect and were using settings from the ADSL Internet Settings Tables, return to the tables and find the next most frequently used settings—those labeled (2) if you just entered (1), or (3) if you just entered (2), and repeat steps 3–7 above.

18

ADSL X4 User Guide