ZyXEL Communications 2602HWNLI-D7A manual ∙ Unix Setup

Prestige 2602HWNLI-D7A Support Notes

Configuration:

1.Active, use the space bar to turn on the syslog option.

2.Syslog IP Address, enter the IP address of the UNIX server that you wish to send the syslog.

3.Log Facility, use the space bar to toggle between the 7 different local options.

∙UNIX Setup

1.Make sure that your syslogd starts with -rargument.

-r, this option will enable the facility to receive message from the network using an Internet domain socket with the syslog services. The default setting is not enabled.

2. Edit the file /etc/syslog.conf by adding the following line at the end of the /etc/syslog.conf file.

local1.*/var/log/zyxel.log

Where /var/log/zyxel.log is the full path of the log file.

3. Restart syslogd.

∙CDR log(call messages)

Format:

sdcmdSyslogSend( SYSLOG_CDR, SYSLOG_INFO, String ); String = board xx line xx channel xx, call xx, str

board = the hardware board ID line = the WAN ID in a board channel = channel ID within the WAN

call = the call reference number which starts from 1 and increments by 1 for each new call str = C01 Outgoing Call dev xx ch xx (dev:device No. ch:channel No.)

C01 Incoming Call xxxxBps xxxxx (L2TP,xxxxx means Remote Call ID)

C01 Incoming Call xxxx (means connected speed) xxxxx (means Remote Call ID)

L02 Tunnel Connected(L2TP)

C02 OutCall Connected xxxx (means connected speed) xxxxx (means Remote Call ID) C02 CLID call refused

73

All contents copyright (c) 2007 ZyXEL Communications Corporation.