ZyXEL Communications 2602HWNLI-D7A Relay to Pstn, How to connect Lifeline and DSL connection

Prestige 2602HWNLI-D7A Support Notes

Relay to PSTN

The Relay to PSTN field can be found under PSTN configuration WEB GUI in Relay to PSTN section. This field is used to specify phone numbers to which the Prestige will always send calls through the regular PSTN phone service without pushing prefix. In other words, numbers which specify on this field do not need to dial prefix number to be dialed out. However, these numbers must be for phones on the PSTN (not VOIP phones) and currently, P2602HWNLI –D1A support up to nine entries under this field.

After configuring the PSTN setup, click “Apply” to save changes back to P2602HWNLI – D1A.

Note: It is recommended to configure your local emergency services such as Police Dept, Fire Dept, Emergency Medical services phone number in this field. Thus in any cases, these unit can be reach in case of emergency by dialing their number without prefix, regardless if there are power loss.

How to connect Lifeline and DSL connection

To use both VOIP and regular phone service with P2602HWNLI-D1A’s lifeline feature. You will need to connect ADSL line and phone line appropriately and make proper configuration.

Making the correct connection it allows you to still receive phone calls while someone else is making outgoing VoIP call though Prestige’s 2 pots port, the following figure shows you how to connect your phone and DSL service.

If your ADSL line type is Splitter type you ISP will provide you with splitter otherwise it should be splitterless. For correct info you may check with your service provider as for which type of line you have.

Firgure 1 Splitter type

126

All contents copyright (c) 2007 ZyXEL Communications Corporation.