Fostex PD606 owner manual Selecting the drive for recording

Chapter 5: Recording/Playback

Selecting the drive for recording

The PD606 is equipped with the DVD multi drive and hard disk drive.

Before recording, select the drive to which recording is made. By default, partition 1 (PT01) on the hard disk drive is selected as the current drive.

To record to a DVD-RAM disk or another partition, select the desired drive by following the procedure below.

In the procedure below, it is assumed that a formatted DVD-RAM disk is set to the DVD drive.

FILE SEL

	SHIFT						DRV,PAT.
									LINK MASTER	space	AB
	POWER			QUICK SET	TIME	FILE SEL	LIGHT	EXIT	ENTER / YES
	ON									1	2
										GHI	JK
	OFF
				SHIFT	TC SET	DRV,PAT. CONTRAST		BATT	MENU	4	5
MS R			1	1 / 3 / 5 + 2 / 4 / 6			ACCESS			PQRS	TU
C4	L		2	ST BUS
C3 6			3	READY TRK			HDD	DVD		7	8
C2	5		4	C1
	ST			PD606 LOCATION RECORDER
	SOLO
		MONO
	MONITOR

1)While stopped, press the [SHIFT] key to enter shift mode, followed by the [FILE SEL / DRV, PAT.] key.

The display changes to show the screen for selecting a drive. On the screen, the current selection is initially highlighted.

<Note>: You can also bring up the screen for selection a drive (as shown above) by the following methods.

1)While stopped, press the [SHIFT] key to enter shift mode, followed by the [ENTER/YES] key.

The display shows the MENU list screen for selecting the desired main menu.

2)Use the [MENU] dial to select "DRV/PAT SEL" and press the [ENTER/YES] key.

The display shows the screen for selecting a drive as above.

2)Use the [MENU] dial to select the desired drive (the DVD drive or a partition) and press the [ENTER/YES] key.

The selected drive is loaded and the display shows the Home screen of the current drive as below (in the both examples below, no recording has been made to the current drive).

<When the DVD drive is selected> <When partition 2 is selected>

Location Recorder Model PD606 87