Fostex PD606 Default LTC start time setting Default LTC start, 190, Press the ENTER/YES key again

Chapter 8: MENU mode/TC SETUP menu

Default LTC start time setting [Default LTC start]

Using the "Default LTC start" menu item, you can set the desired default LTC start time value (the initial setting is "1h 00m 00s"). This value is used when the generator mode is set to "Ext Run" but no external time code is fed to the unit.

<Note>: The unit does not recognize paused time code as "correct" time code. It recognizes time code when receiving more than two continuous frames.

1)When the unit is stopped, press the [SHIFT] key to light the [SHIFT] indicator, followed by the [TIME/TC SET] key.

The display now shows the TC SETUP menu screen.

2)Use the [MENU] dial to select the “Default LTC start” menu item, and press the [ENTER/YES] key.

The current LTC start time is shown (initially, "01h 00m 00s" is shown).

3)Press the [ENTER/YES] key again.

The second value flashes and you can now edit the default LTC start time.

Flashing

4)Edit the time value to the desired value, and press the [ENTER/YES] key to confirm your setting.

Use the [MENU] dial (or the alphanumeric keys) to enter a desired value and use the [] / [] keys to move the cursor position.

The setting is stored to the Flash ROM of the unit.

5)Press the [EXIT] key repeatedly until you exit the MENU mode.

190 Location Recorder Model PD606