Fostex PD606 Phase setting for channels 1 through, Controlling signals sent to the stereo bus

Chapter 5: Recording/Playback

Phase setting (for channels 1 through 6)

You can reverse the phase of the input signal by pressing the [SHIFT] key followed by the [PFL/SEL] key of the desired channel. The [REV.] indicator under the bargraph meter of a phase-reversed channel is lit. To disable the phase reverse, press the [SHIFT] key followed by the [PFL/SEL] key again.

[PFL/SEL] key

SHIFT

[REV.] indicator

Controlling signals sent to the stereo bus

Using the [PAN] key on each of channels 1 through 6, you can select "L", "C" or "R" for the panning position of the channel signal sent to the stereo bus. Each time you press the [PAN] key, the option ("C", "R", "OFF" or "L") changes, and the corresponding indicator lights. When "Off" is selected, no indicator is lit and the channel signal is not sent to the stereo bus.

L
	light in green		light in yellow		unlit
C
		unlit	light in yellow		unlit
R
		unlit	light in yellow	light in green
OFF
		unlit	unlit		unlit

[PAN] keys

Using the [SEND LEVEL] control on each of channels 1 through 6, you can adjust the signal level sent to the stereo bus. Using the [ST BUS MASTER] control, you can adjust the stereo bus master level.

[ST BUS MASTER] control

[SEND LEVEL] controls

When the READY indicator in the stereo bus master section flashes, you are ready to record the stereo bus signals or digital input 7/8 (depending on the setting of the "Rec source sel" item) to the stereo tracks (see pages 91 and 146).

<Note>: By default, each [SEND LEVEL] control affects the level of the corresponding input signal sent to the stereo bus. However, by setting the "Disk Feed" item in the "SYS SETUP" menu of the MENU mode to "Post", it also affects the level of the signal sent to the corresponding track as well as the level of the signal sent to the stereo bus (see page 169).

Location Recorder Model PD606 83