Fostex PD606 owner manual Digital output signal format selection Digital out, 147

Chapter 8: MENU mode/SYS SETUP menu

<Note>: When you set the "ST-LR" source to "Digital", you cannot record the stereo buss signals to the ST tracks.

6)Press the [EXIT] key repeatedly until you exit the MENU mode.

<Note>: The display examples below show when channel pairs are set to "DIGITAL" on the record source select screen. The digital signal format (AES/EBU or S/P DIF) is automatically detected. If a valid digital signal is not available, the record source automatically switches to the analog signals.

<Default>	When CH1-2 and CH3-4
	are set to "DIGITAL"

When all channels are set to "DIGITAL"

Digital output signal format selection [Digital out]

The “Digital out” menu item selects the format (AES/EBU or S/P DIF) of the digital signal which is output from the [DIGITAL I/O] connector.

1)While the unit is stopped, press the [SHIFT] key to light the SHIFT indicator, followed by the [ENTER/YES] key.

2)While “SYS SETUP” is highlighted, press the [ENTER/YES] key.

The display now shows the SYS SETUP menu screen.

3)Use the [MENU] dial to select the “Digital out” menu item and press the [ENTER/YES] key.

The current setting starts flashing and you can now select the desired option.

Flashing

Options

You can select from among “AES/EBU” and “S/P DIF” (the default is “AES/EBU”).

AES/EBU IEC 60958 Part3 (AES/EBU) format digital signal is output.
S/P DIF	IEC 60958 Part2 (S/P DIF) format digital signal is output.

4)Use the [MENU] dial to select the desired option and press the [ENTER/YES] key to confirm your setting.

5)Press the [EXIT] key repeatedly until you exit the MENU mode.

Location Recorder Model PD606 147