Prestige 794M User’s Guide

The following table describes the labels in this screen.

Table 15 LAN: Ethernet Client Filter: Active PC in LAN

LABEL

DESCRIPTION

 

 

IP Address

This field displays the IP address of an Ethernet device connected to the Prestige.

 

 

MAC Address

This field displays the MAC address associated with the IP address in the IP

 

Address field.

Add

Click Add to add the select entry(ies) in the Ethernet Client Filter screen.

 

 

3.5 Port Setting

Use the Port Setting screen to configure the LAN port settings on the Prestige. Click Configuration, LAN and Port Setting to display the screen as shown next.

Figure 23 LAN: Port Setting

The following table describes the labels in this screen.

Table 16 LAN: Port Setting

LABEL

DESCRIPTION

 

 

Port 1 .. 4

Select the speed and the duplex mode of the Ethernet connection on this port.

Connection

Choices are Auto, 10Mfalfduplex, 10Mfullduplex, 100Mhalfduplex and

Type

100Mfullduplex.

 

 

Selecting Auto (auto-negotiation) allows one port to negotiate with a peer port

 

automatically to obtain the connection speed and duplex mode that both ends support.

 

When auto-negotiation is turned on, a port on the Prestige negotiates with the peer

 

automatically to determine the connection speed and duplex mode. If the peer port

 

does not support auto-negotiation or turns off this feature, the Prestige determines the

 

connection speed by detecting the signal on the cable and using half duplex mode.

 

When the Prestige’s auto-negotiation is turned off, a port uses the pre-configured

 

speed and duplex mode when making a connection, thus requiring you to make sure

 

that the settings of the peer port are the same in order to connect.

IPv4 TOS

Select Enable to set the Prestige to send traffic based on the priority level.

Priority Control

Select Disable to set the Prestige to treat all traffic equally.

 

 

Chapter 3 LAN

42