ZyAIR Access Point Series User’s Guide

 

Table 13-4 Menu 3.5.2 Roaming Configuration

 

 

FIELD

DESCRIPTION

 

 

Active

Press [SPACE BAR] and then [ENTER] to select Yes to enable roaming on the ZyAIR if you

 

have two or more ZyAIRs on the same subnet.

Port #

Type the port number to communicate roaming information between access points. The port

 

number must be the same on all access points. The default is 16290. Make sure this port is

 

not used by other services.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

13.3.3 Configuring Multiple ESS (for ZyAIR B-3000 only)

Follow the steps below to configure Multiple ESS on your ZyAIR.

Step 1. From the main menu, enter 3 to open Menu 3 – LAN Setup.

Step 2. Enter 5 to display Menu 3.5 – Wireless LAN Setup.

Menu 3.5 - Wireless LAN Setup

Operating Mode= Multiple ESS

Edit MAC Address Filter= N/A

ESSID= N/A

Edit Roaming Configuration= No

Hide ESSID= N/A

Edit Multiple ESS Configuration= Yes

Channel ID= CH01 2412MHz

Edit Bridge Link Configuration= N/A

RTS Threshold= 2432

Block Intra-BSS Traffic= No

Frag. Threshold= 2432

Number of Associated Stations= 32

WEP Encryption= N/A

Breathing LED= Yes

Default Key= N/A

Output Power= 17dBm

Key1= N/A

 

Key2= N/A

 

Key3= N/A

 

Key4= N/A

 

Authen. Method= N/A

 

Press ENTER to Confirm or ESC to Cancel:

Figure 13-8 Menu 3.5 Wireless LAN Setup

Step 3. In the Operating Mode field, press [SPACE BAR] to select Multiple ESS and press [ENTER].

Step 4. Move the cursor to the Edit Multiple ESS Configuration field. Press [SPACE BAR] to select Yes and press [ENTER]. Menu 3.5.3 – Multiple ESS Configuration displays as shown next.

13-8

LAN Setup