Sets the length of time, in tenths of a second, that the modem waits before hanging up after a loss of carrier. This allows for a temporary carrier loss without causing the local modem to disconnect.
S11 - DTMF Tone Duration
Sets the duration of tones in DTMF dialing. This value has no effect on pulse dialing.
S12 - Escape Prompt Delay (EPD)
Defines the maximum period, in fiftieths of a second, allowed between receipt of the last character of the three escape character sequence from the DTE and sending of the OK result code to the DTE. If any characters are detected during this time, the OK will not be sent. Note that sending of the OK result code does not affect entry into command mode.
S18 - Test Timer
Sets the length of time, in seconds, that the modem conducts a test (commanded by &Tn) before returning to the command mode. If this register value is zero, the test will not automatically terminate; the test must be terminated from the command mode by issuing an &T0 or H command. When S18 is
S25 - Delay To DTR
Sets the length of time that the modem will ignore DTR for taking the action specified by &Dn. Its unit is one hundredth of a second.
S26 - RTS to CTS Delay
Sets the time delay, in hundredths of a second, before the modem turns CTS ON after detecting an
S30 - Disconnect Inactivity Timer
Sets the length of time, in minutes, that the modem will stay online before disconnecting when no data is sent or received. In
Result Code Options
"ATXn" Result Code Option Table
The following table shows the different options available when setting the ATXn command:
ATV0 | ATV1 | X0 | X1 | X2 | X3 | X4 | X5 | X6 | X7 |
0 | OK | V | V | V | V | V | V | V | V |
Status Registers & Result Codes 23
