ZyXEL Communications Comet 336P user manual Status Registers & Result Codes, Register Definitions

5 Status Registers & Result Codes

In most bit-mapped S-registers, the default bit value is 0. Non-0 default values are followed by an asterisk. Some bits are reserved for factory use and should not be changed.

S-Registers "ATSn=x"

Command	Function & Description	Range	Ref.
S0	Number of rings before Auto Answer. 0 value disables auto-	0-255 (0)	ATA
	answer.
S1	Ring counter.	0-255 (0)
S2	ASCII value of Escape character.	0-255 (43)
S3	ASCII value of Carriage Return character.	0-127(13)
S4	ASCII value of Line Feeder character.	0-127 (10)
S5	ASCII value of Backspace character.	0-32 (8)
S6	Waiting time before blind dialing. (seconds)	2-255 (2)
S7	Wait foe carrier after dial. (seconds)	1-255 (50)
S8	Pause time for comma. (seconds)	1-255 (50)
S9	Carrier detect response time. (1/10 seconds)	1-255 (6)
S10	Delay between loss of carrier and hang-up. (1/10 seconds)	1-255 (14)
S11	DTMF (Touch tone) tone duration. (1/10 seconds)	50-255 (95)
S12	Escape guard time. (1/50 seconds)	0-255 (50)
S18	Test timer. (seconds)	0-255 (0)
S25	Delay to DTR. (1 second for sync mode 1; 0.01 for otherwise)	0-255 (5)
S26	RTS to CTS delay interval. (0.01 seconds)	0-255 (1)
S30	Inactivity disconnect timer. (0.1 seconds)	0-255 (0)

S-Register Definitions

S0 - Number of Rings to Auto-Answer

Sets the number of the rings required before the modem automatically answers a call. Setting this register to zero disables auto-answer mode.

S1 - Ring Counter

S1 is incremented each time the modem detects a ring signal on the telephone line. S1 is cleared if no rings occur over an eight second interval.

S2 - Escape Character

S2 holds the decimal value of the ASCII character used as the escape character. The default value corresponds to an ASCII '+'. A value over 127 disables the escape process, i.e., no escape character will be recognized.

S3 - Carriage Return Character

Sets the command line and result code terminator character. Pertains to asynchronous operation only.

Status Registers & Result Codes 21