Talking

Lit steadily

(red)

Charging

Lit steadily

(green)

Incoming call

Flashes in same pattern as telephone ring (red)

Voice mail

Flashes every 2 seconds (red)

No telephone line

Flashes every 1 seconds (red)

SOUND SIGNALS

A long warbling tone

Signals an incoming call

 

Single tone

A key is pressed

 

Two short beeps

Call waiting / MIC mute

 

One long beep

Confirmation tone / Page signal / Call

 

 

back

 

Three short beeps

Error tone / Out of range

 

Two short beeps every 15 seconds

Low battery warning

 

 

 

 

TROUBLESHOOTING

 

 

TELEPHONE

 

 

No dial tone

Check installation:

∙ Is the base unit plugged into the telephone line and AC power source? If the telephone line is not properly connected to the base unit NO LINE will appear on the handset display.

∙ Is the AC power source turned on at the socket? ∙ Are the batteries properly installed in the handset?

Dial tone is OK, but cannot dial out

∙ Try moving the handset closer to the base unit.

∙ If this doesn’t work, try a different position for the base unit. Typically, the higher you place the base unit, the better the reception.

∙ The battery charge level may be low. Check the LCD display for the low battery-warning signal. If the battery is low, place the handset in the base unit’s charging cradle to charge.

28

Page 28
Image 28
Sanyo LNS-W10 instruction manual Sound Signals, Troubleshooting, No dial tone, Dial tone is OK, but cannot dial out