ZyXEL Communications RESET, Press, RESET, RESET, 1 Beep, Storage, 2 Beeps, Password, COPY/SYNC, Release to, IP Address, 5 more seconds, Release to Reset, Clear All Settings

Chapter 1 Getting to Know Your NSA

Note that both SATA and eSATA hard disks are treated as internal or SATA volumes in the Storage screen (Section 8.3 on page 165). Any hard disk connected to the USB port(s) is considered an external or USB volume.

1.1.3 COPY/SYNC Button

Use the COPY/SYNC button on the front panel to copy or synchronize files between a connected USB device and the NSA. See Section 10.11 on page 212 for more details on how to configure the copy/sync settings.

1.1.4 RESET Button

Use the RESET button on the rear panel to restore the NSA’s default settings.

Figure 2 The RESET Button

Press	1 Beep	2 Beeps
			5 more seconds
	Release to Reset		Release to
	IP Address
			Clear All Settings
	Password

•Press the RESET button until you hear one beep (after about two seconds), then release it. You will hear one more beep after you release the button.

This resets the NSA’s IP address and password to the default values.

•Press the RESET button until you hear two beeps. After the second beep, continue pressing the button for five more seconds, then release it. You will hear three quick beeps after you release the button.

This resets the NSA to the factory default configuration. All settings you have configured on the NSA, including IP address, password, user accounts, groups, and so on will be reset to the factory defaults.

The reset process does NOT affect the volume settings, nor data stored on the NSA.

You should periodically back up your configuration file to your computer (see Section 18.5 on page 333 for details about managing the NSA’s configuration file). You could then restore your configuration in the event that you or someone else reset the NSA to the factory defaults.

Note: Keep the NSA in a secure location in order to prevent unauthorized reset of the device.

You may need to close and re-open the NAS Starter Utility to discover the NSA. This is because the NSA automatically re-acquires IP address information, so its IP address may change. If no IP address information is assigned, the NSA uses Auto-IP to assign itself an IP address and subnet mask. For example, you could connect the NSA directly to your computer. If the computer is also set to get an IP address automatically, the computer and the NSA will choose addresses for themselves and be able to communicate.

	19
Media Server User’s Guide