CHAPTER 5
Introduction to CLI
This chapter introduces the line commands.
5.1 Command Line Interface Overview
In addition to the web configurator, you can use line commands to configure the Prestige. It is recommended that you use the web configurator for everyday management of the Prestige and that you use line commands for advanced Prestige diagnosis and troubleshooting. If you have problems with your Prestige, customer support may request that you issue some of these commands to assist them in troubleshooting.
5.1.1 Accessing the Command Line Interface
Note: Only one CLI management session is allowed at a time.
Use the following steps to telnet into your Prestige.
1Connect your computer to the
2Make sure your computer IP address and the Prestige IP address are on the same subnet. In Windows, click Start (usually in the bottom left corner), Run and then type telnet 192.168.100.1 (the default management IP address) and click OK.
3A login screen displays. For your first login, enter the default administrator login username “admin” and password “1234”.
4After you have entered the username and password, press [ENTER] to display the command prompt.
Chapter 5 Introduction to CLI | 40 |