The following table describes the CM commands. By default, you access the CM group of commands when you log into the CLI every time. Use the CM commands to perform basic system settings, diagnostics or configuration file maintenance.
Table 5 CM Command Summary
COMMAND |
| DESCRIPTION |
|
|
|
load_config | <IpAddress> | Uploads a text based configuration from a TFTP server. |
| <Filename{127}> | After the upload process is complete, the device executes |
|
| the commands line by line. |
logout |
| Exits from the CLI session. |
ping | <IpAddress> | Tests the connection to a device. Specify the IP address |
|
| of the device in dotted decimal notation (for example, |
|
| 192.168.1.1). |
reset |
| Restarts the device. |
|
| Note: All unsaved configuration changes are |
|
| lost once you restart the device. |
restoreDefaults |
| Resets the device back to the factory defaults. |
|
| Note: All your settings will be erased. |
run_app |
| Executes channel band scanning. |
save |
| Saves configuration changes to memory. |
scan_band | <Band{0..31}> | Sets the predefined scan band (Bitmap). |
scan_set | <index{0..4}> | Sets the scan profile set. You can configure up to five |
| <Band{1..5}> <start> | scan profiles in the set. The Prestige scans all profiles |
| <end> [freq_offset] | when you activate band scanning. |
| The frequency offset (freq_offset) is only applicable | |
|
| |
|
| for European scan plan. |
|
|
|
scan_set_clear |
| Clears the scan profile. |
scan_show |
| Displays scan profile setting. |
telnet_pass | <Password{15}> | Sets the Telnet administrator login password. |
telnet_user | <Name{15}> | Sets the Telnet administrator login username. |
version |
| Displays the firmware version. |
web_admin_id | <WebAdminId{15}> | Sets the web configurator administrator login username. |
|
| Note: You must save the changes and restart |
|
| the device to make the changes take |
|
| effect. |
Chapter 5 Introduction to CLI | 50 |