TROY Group MAN-EXT2000 manual Switches 2 and 3 10baseT/10base2

OFF

Sw1 Sw2 Sw3 Sw4

ON

XConnect II Rear View

Figure 2-1

XConnect II Switches

time the print server is powered on, the print server parameters (for example, node name, serial port speed, etc.) will be returned to the factory defaults. If you use this switch, don't forget to put it back to the OFF position after the factory default settings have been restored.

After the print server is powered on and running, this switch can be used to print out a self-test page. This is done by moving the switch to the ON position and then quickly putting it back to the OFF position.

Switches 2 and 3 (10baseT/10base2)

These switches do not need to be changed from the default ON position with newer versions of the XConnect II or XConnect II Lite print server firmware. However, if you are using 10baseT Ethernet, putting the switches in the OFF

Installation 2-3