TROY Group MAN-EXT2000 manual Thin Ethernet Cable 50 ohm

Thin	A
Ethernet
Cable
"T"
Thin
Ethernet
Cable
50 ohm	B
Terminator
"T"

Thin

Ethernet

Cable

H1000

Figure 2-5

Connecting the Print Server to a 10base2 thin Ethernet network

Connecting the XConnect II or XConnect II Lite-2 to a Thin Ethernet Network

To connect an XConnect II or XConnect II Lite-2 to a thin Ethernet network, first check to see that switches 2 and 3 (10baseT/10base2) are in the ON position.

If you are installing the print server onto an existing network, the "T" connector may already be installed on the cable. If this is the case, simply connect the "T" connector to the BNC connector on the print server's BNC connector as shown in figure 2-5A (if the connection is in the middle of the thin Ethernet segment) or 2-5B (if the connection is at the end of the thin Ethernet segment). This operation can be performed without impacting the operation of the network.

If the "T" connector is not already installed, proceed as follows (caution: if you are connecting to a live network,

2-14 Installation