8.Rotate the tire and at the same time rotate the turnbuckle to shorten the length of the brake linkage to increase the brake pressure. When you feel the brake begin to engage, stop adjusting the turnbuckle.
9.Place the control lever in the park brake slot "FIG. 28". The tire should not rotate when the control lever is in the park brake position.
10.Place the control lever in the neutral position. The tire should rotate freely.
11.Close the hydraulic pump’s bypass valve.
12.Repeat steps 3 thru 11 for the other side.
13.Remove the jack stands and lower the unit. It is now ready to operate.
HYDRAULIC PUMP BELT ADJUSTMENT
The pump drive belt tension remains constant by means of a tension idler and spring "FIG. 30". There is no tension adjustment of this belt.
NOTE: Replace the belt every 400 hours or every two (2) years whichever comes first.
WARNING: If the pump belt fails, loss of control will occur especially when operating on a slope. If you lose steering control while operating the machine, place the steering control levers in the park brake position immediately. Inspect the machine and involve your Hustler dealer to resolve the problem before continuing to operate.
SPRING
PUMP BELT
DRIVE
TENSION
IDLER
FIG. 30
DECK DRIVE BELT ADJUSTMENT
The spindle belt tension remains constant by means of a tension idler and spring "FIG. 31". The spring tension should be such that the belt does not slip under normal operating load conditions, assuming the belt is not excessively worn or damaged. As belt stretches and wears in, adjustment may become necessary. To increase belt tension, move the spring chain one (or more) link(s) at the anchor bracket "FIG. 31". Installed spring length should be 9.0" ± .3" (22.8 cm ± .76 cm) originally with adjustments of .60" (15.2mm) per chain link "FIG. 32".
IMPORTANT: Do not over tension the spring to compensate for a badly worn belt or pulley.
108604 10/08 |