Husqvarna HCS9, HCS13 manual Assembly

Page 12

ASSEMBLY

12.Re-install the pulley shield.

13.Cut the blower housing along the dashed line to fit the 52" and 61" decks. Drill the two small holes indicated with the 11/32" drill bit. The blower housing will fit 42" and 48" units with no modifications. Figure 2.

14.Remove the (4) 1/4 x 3/4 carriage bolts from the deck plate, and the (4) 3/8" nyloc nuts from the inside of the blower housing. Figure 1.

15.Place the deck plate on the welded studs in the blower housing. Install and tighten the (4) 3/8" nyloc nuts that were just removed. Figure 1.

16.Install the (4) 990074, 1/4 x 3/4 carriage bolts thru the square holes in the deck plate from the inside out.

17.Place the (4) 990598, 1/4 flat washers and

(4) 108120, 1/4" nyloc nuts on the carriage bolts. The lanyard must be placed on the top front carriage bolt between the flat washer and the blower housing. Tighten the nuts. Figure 1.

CUT ALONG DASHED LINES PER DECK SIZE AND DRILL CORRECT HOLES TO 11/32” PER DECK SIZE.

61” DECK HOLE

52” DECK HOLE

 

61” DECK TRIM LINE

52” DECK TRIM LINE

FIGURE 2

12

Image 12
Contents Collection System Operators Manual Husqvarna. All Rights Reserved Index Operators GuideFeatures & Controls Safety Rules General InformationOperation Assembly Unpacking InstructionsRear Guard Strap Lanyard Hitch Assembly Hitch PIN Latch Hood Assembly Hood Hinge Hood Assembly Blower/Drive Kit Assembly Deck Plate PIN Operation Operating the Collection SystemService and Maintenance TransportCaring For Hoses Troubleshooting Guide Spindle Drive Assembly Parts Illustrations Hood Assembly QTY Description Hitch Assembly Hitch Blower Assembly Floor Weldment Weight KIT Model HCS13Model HCS9 Mounting KIT Hitch BRACKET, RIGHT, W/DECAL Model HCS9 Hitch Bracket W/DECALS, Right BAG Assembly Drive KIT Assembly 539 111275 42 Inch Deck539 111276 48 Inch Deck 539 111277 52 Inch Deck 539 111278 61 Inch Deck