Husqvarna 535RXT manual Sharpening grass cutters and grass blades, Sharpening the saw blade

Page 11

GENERAL SAFETY PRECAUTIONS

General rules

Only use cutting attachments with the guards we recommend! See the chapter on Technical data.

Keep the teeth of the blade correctly sharpened! Follow our instructions and use the recommended file gauge. An incorrectly sharpened or damaged blade increases the risk of accidents.

Keep the correct setting on the saw blade! Follow our instructions and use the recommended setting tool. An incorrectly set saw blade increases the risk of jamming and blade thrust, and damage to the saw blade.

Check the cutting attachment for damage or cracks. A damaged cutting attachment should always be replaced.

Sharpening grass cutters and grass blades

•See the cutting attachment packaging for correct sharpening instructions. Sharpen blades and cutters using a single-cut flat file.

•Sharpen all edges equally to maintain the balance of the blade.

!

WARNING! Always discard a blade that is

bent, twisted, cracked, broken or

 

 

damaged in any other way. Never attempt

 

to straighten a twisted blade so that it

 

can be reused. Only use original blades

 

of the specified type.

Sharpening the saw blade

•See the cutting attachment packaging for correct sharpening instructions.

A correctly sharpened blade is essential for working efficiently and to avoid unnecessary wear to the blade and brush cutter.

•Make sure that the blade is well supported when you file it. Use a 5.5 mm round file with a file holder.

•The filing angle is 15°. File alternate teeth to the right and those in between to the left. If the blade has been heavily pitted by stones it may be necessary to dress the top edges of the teeth with a flat file, in exceptional cases. If so, this should be done before filing with a

English – 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents 535RX, 535RXT Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the brush cutter? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipment 535RX, 535RXT Stop switch Cutting attachment guard Vibration damping systemMuffler Quick releaseCutting equipment Cutting equipmentLocking nut Sharpening the saw blade Sharpening grass cutters and grass bladesTrimmer head Attachment without an approved guard AssemblySee the chapter on Technical data. If an Fitting the guard extensionFitting the blade guard and saw blade Fitting a blade guard, grass blade and grass cutterFitting other guards and cutting attachments Triobalance harness Adjusting the harness and brush cutterStandard harness Correct balance Fuel Fuel safetyFuel Handling Use. This also applies during idling. Be FuelingMixing Muffler gets very hot during and afterStarting Starting and StoppingCheck before starting Starting and stoppingStopping For throttle handles with a start throttle lockABC of clearing Basic safety rulesWorking Techniques General working instructionsRotating, as this can result in serious Up into the eyes causing blindness orAreas where it is difficult to see Is running or the cutting equipment isBrush cutting with a saw blade Forestry clearing using a saw bladeClearing Grass clearing using a grass bladeGrass trimming with a trimmer head TrimmingSweeping CuttingCarburetor MaintenanceBevel gear MufflerCooling system Oiling the air filter Cleaning the air filterAir filter Spark plugMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Auto Trimmy SII Page Page Original instructions 1154017-95
Top Page Image Contents