Husqvarna 535RXT manual For throttle handles with a start throttle lock, Stopping

Page 21

STARTING AND STOPPING

Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled.

!

WARNING! When the engine is started

with the choke in either the choke or

 

 

start throttle positions the cutting

 

attachment will start to rotate

 

immediately.

Hold the body of the machine on the ground using your left hand (CAUTION! Not with your foot!). Grip the starter handle, slowly pull out the cord with your right hand until you feel some resistance (the starter pawls grip), now quickly and powerfully pull the cord. Never wrap the

starter cord around your hand

Repeat pulling the cord until the engine starts. When the engine starts. return choke control to run position and apply full throttle; the throttle will automatically disengage from the start setting.

CAUTION! Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine.

CAUTION! Do not put any part of your body in marked area. Contact can result in burns to the skin, or electrical shock if the spark plug cap has been damaged. Always use gloves. Do not use a machine with damaged spark plug cap.

For throttle handles with a start throttle lock:

Set the throttle to the start position by first pressing the throttle lockout and the throttle trigger, then pressing the start throttle button (A). Then release the throttle lockout and the throttle trigger, followed by the start throttle button. The throttle function is now activated. To return the engine to idle, press the throttle lockout and throttle trigger again.

Stopping

Stop the engine by switching off the ignition.

CAUTION! The stop switch automatically returns to the start position. In order to prevent unintentional starting, the spark plug cap must be removed from the spark plug when assembling, checking and/or performing maintenance.

English – 21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents 535RX, 535RXT Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the brush cutter? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentCutting attachment guard Stop switchVibration damping system 535RX, 535RXTMuffler Quick releaseCutting equipment Locking nutCutting equipment Sharpening the saw blade Sharpening grass cutters and grass bladesTrimmer head See the chapter on Technical data. If an AssemblyFitting the guard extension Attachment without an approved guardFitting the blade guard and saw blade Fitting a blade guard, grass blade and grass cutterFitting other guards and cutting attachments Adjusting the harness and brush cutter Standard harnessTriobalance harness Correct balance Fuel safety Fuel Handling Fuel Mixing FuelingMuffler gets very hot during and after Use. This also applies during idling. BeCheck before starting Starting and StoppingStarting and stopping StartingStopping For throttle handles with a start throttle lockWorking Techniques Basic safety rulesGeneral working instructions ABC of clearingAreas where it is difficult to see Up into the eyes causing blindness orIs running or the cutting equipment is Rotating, as this can result in seriousBrush cutting with a saw blade Forestry clearing using a saw bladeGrass trimming with a trimmer head Grass clearing using a grass bladeTrimming ClearingSweeping CuttingCarburetor MaintenanceMuffler Cooling systemBevel gear Air filter Cleaning the air filterSpark plug Oiling the air filterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Auto Trimmy SII Page Page Original instructions 1154017-95
Top Page Image Contents