Husqvarna 535RXT Adjusting the harness and brush cutter, Standard harness, Triobalance harness

Page 16

ASSEMBLY

Adjusting the harness and brush cutter

WARNING! When using a brush cutter it

! must always be hooked securely to the harness. Otherwise you will be unable to control the brush cutter safely and this can result in injury to yourself or others. Never use a harness with a defective quick release.

Standard harness

Quick release

At the front is an easily accessible, quick release. Use this if the engine catches ﬁre or in any other emergency situation that requires you to free yourself from the machine and harness.

Spreading the load on your shoulders

A well-adjusted harness and machine makes work much easier. Adjust the harness for the best working position. Tension the side straps so that the weight is evenly distributed across both shoulders.

Correct height

1Forestry clearing

The machine should be supported in a harness when forestry clearing so that the cutting equipment is angled slightly forwards in relation to the ground. Adjust the

height using the strap on the harness for the support hook.

2Grass clearing

The machine should be supported in a harness when grass clearing so that the cutting equipment is parallel to the ground.

Triobalance harness

Quick release

Push down the red release lever to release the machine from the harness.

Adjusting the harness

1 Tighten the hip strap so that it sits securely.

16 – English

Image 16

Contents 535RX, 535RXT KEY to Symbols SymbolsContents Introduction Dear customerWhat is WHAT? What is what on the brush cutter?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system 535RX, 535RXTQuick release MufﬂerLocking nut Cutting equipmentCutting equipment Sharpening grass cutters and grass blades Sharpening the saw bladeTrimmer head Assembly See the chapter on Technical data. If an Fitting the guard extension Attachment without an approved guardFitting a blade guard, grass blade and grass cutter Fitting the blade guard and saw bladeFitting other guards and cutting attachments Standard harness Adjusting the harness and brush cutterTriobalance harness Correct balance Fuel Handling Fuel safetyFuel Fueling MixingMufﬂer gets very hot during and after Use. This also applies during idling. BeStarting and Stopping Check before startingStarting and stopping StartingFor throttle handles with a start throttle lock StoppingBasic safety rules Working TechniquesGeneral working instructions ABC of clearingUp into the eyes causing blindness or Areas where it is difﬁcult to seeIs running or the cutting equipment is Rotating, as this can result in seriousForestry clearing using a saw blade Brush cutting with a saw bladeGrass clearing using a grass blade Grass trimming with a trimmer headTrimming ClearingCutting SweepingMaintenance CarburetorCooling system MufﬂerBevel gear Cleaning the air ﬁlter Air ﬁlterSpark plug Oiling the air ﬁlterMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Auto Trimmy SII Page Page Original instructions 1154017-95