Uniden BC75XLT owner manual Care and Maintenance, Resetting the Scanner, General Use, Location

Page 53

Care and Maintenance

Resetting the Scanner

If the scanner’s display locks up or stops operating properly, you might need to reset the scanner.

CAUTION: This procedure clears all the information you have stored in the scanner.. Before you reset the scanner, try turning it off and back on to see if it begins working properly.. Reset the scanner only when you are sure it is not working properly..

1.Turn off the scanner.

2.While holding down 2, 9, and Hold, turn on the scanner. It takes about 3 seconds to initialize and CLEAr appears.

General Use

•Turn the scanner off before disconnecting the power.

•Always write down the programmed frequencies in the event of memory loss.

•If memory is lost, simply reprogram each channel. The display shows 000.0000 in all channels when there has been a memory loss.

•Always press each button firmly until you hear the entry tone for that key entry.

Location

•Do not use the scanner in high-moisture environments such as the kitchen or bathroom.

•Avoid placing the unit in direct sunlight or near heating elements or vents.

53

Image 53

Contents BC75XLT Owner’s Precautions Page Contents Page Unlock Priority Delay Keylock Backlight PC Programming FCC Wants You to Know Scanning Legally Page Introduction BC75XLT Feature HighlightsPage Page Frequency Range USA Band Plan Frequency Range MHz Step Mode kHz TransmissionStep Mode Transmission MHz KHz Canada Band Plan Scanning basics What is Scanning?What is Searching? Simplex Operation Conventional ScanningWhat Are Banks? Service Search BandsRepeater Operation Channel Storage BanksCustom Search Ranges Where To Learn MoreWhat’s In The Box? SetupConnect the Antenna Setting Up the ScannerConnect an Optional Earphone/Headphone Connecting an Optional Extension SpeakerAdjusting the Belt Clip Installing Rechargeable 2300mAh Ni-MH Batteries Installing Non-Rechargeable BatteriesCharging the Ni-MH Batteries through USB Connection LCD Message Batt Meaning Scanner Type Cond Turn On The Scanner Low Battery AlertAdjusting for Interference Adjust SquelchHardware Description BC75XLT Controls and DisplayKeypad Key/Icon Primary Function Key HoldSrch/Svc Key/Icon Primary Function Key ScanPri DlyPgm/E Key/Icon Primary Function Key PSrcClr FuncLine Display Description LCD DisplayDisplay Description To Close Call modeSearch Hold modes Quick Search OperationSearchING Custom Search Service Search Storing Frequencies Erasing a Stored Frequency ScanningPress Func + Pgm Enabling/Disabling Channel BanksManually Select a Channel Scan the Stored ChannelsPage Close Call RF Capture Close Call Operation ModeBand Range MHz To turn a Close Call Low High Using Close Call ModeLocking Out Channels and Frequencies Unlock Temporary Lock OutPermanent Lock Out Priority You cannot lock out frequencies during WX service searchDelay Keylock Mode Delay SpecificationPC Programming BacklightProblem Possible Cause Suggestion TroubleshootingProblem Possible Cause Suggestion Problem Possible Cause Suggestion Resetting the Scanner Care and MaintenanceGeneral Use LocationBirdies CleaningRepairs Page Specifications Seconds Warrantor Uniden America Corporation Uniden One-Year Limited WarrantyProcedure for Obtaining Performance of Warranty