Uniden BC75XLT owner manual Turn On The Scanner, Low Battery Alert

Page 27

determine if the batteries are good and can be charged, it checks them and displays the battery icon. If the scanner judges the batteries are good, the scanner starts charging and the battery icon disappears. If it cannot regard the batteries as good in 60 seconds, the scanner stops checking and the battery icon blinks.

Low Battery Alert

The Low Battery Alert tone sounds every 15 seconds and the battery icon flashes when the battery voltage is low. If it drops below the threshold, the scanner automatically shuts off until the battery is recharged.

Turn On The Scanner

Turn on the scanner after it has been completely charged (Ni-MH batteries) or alkaline batteries have been installed.

Note: Make sure the antenna is connected before you turn on the scanner.

1.You can select the band plan (USA or Canada) when you turn on the scanner (default = USA). Press and hold the

key for 2-3 seconds to turn on the scanner and then press and hold 1 for USA or 2 for Canada. The band plan will remain until you change it again.

2.If this is the first time you have turned on the scanner, All LocOut displays. This means that no frequencies have been saved into channels. Press Srch to begin searching.

27

Image 27

Contents BC75XLT Owner’s Precautions Page Contents Page Unlock Priority Delay Keylock Backlight PC Programming FCC Wants You to Know Scanning Legally Page Introduction BC75XLT Feature HighlightsPage Page Frequency Range USA Band Plan Frequency Range MHz Step Mode kHz TransmissionStep Mode Transmission MHz KHz Canada Band Plan What is Scanning? What is Searching?Scanning basics Simplex Operation Conventional ScanningChannel Storage Banks Service Search BandsWhat Are Banks? Repeater OperationCustom Search Ranges Where To Learn MoreWhat’s In The Box? SetupConnect the Antenna Setting Up the ScannerConnecting an Optional Extension Speaker Adjusting the Belt ClipConnect an Optional Earphone/Headphone Installing Rechargeable 2300mAh Ni-MH Batteries Installing Non-Rechargeable BatteriesCharging the Ni-MH Batteries through USB Connection LCD Message Batt Meaning Scanner Type Cond Turn On The Scanner Low Battery AlertAdjusting for Interference Adjust SquelchKey/Icon Primary Function Key Hold BC75XLT Controls and DisplayHardware Description KeypadDly Key/Icon Primary Function Key ScanSrch/Svc PriFunc Key/Icon Primary Function Key PSrcPgm/E ClrLine Display Description LCD DisplayDisplay Description To Close Call modeSearch Hold modes Operation SearchINGQuick Search Custom Search Service Search Storing Frequencies Enabling/Disabling Channel Banks ScanningErasing a Stored Frequency Press Func + PgmManually Select a Channel Scan the Stored ChannelsPage Close Call RF Capture Close Call Operation ModeBand Range MHz To turn a Close Call Low High Using Close Call ModeLocking Out Channels and Frequencies Temporary Lock Out Permanent Lock OutUnlock Priority You cannot lock out frequencies during WX service searchDelay Keylock Mode Delay SpecificationPC Programming BacklightProblem Possible Cause Suggestion TroubleshootingProblem Possible Cause Suggestion Problem Possible Cause Suggestion Location Care and MaintenanceResetting the Scanner General UseCleaning RepairsBirdies Page Specifications Seconds Warrantor Uniden America Corporation Uniden One-Year Limited WarrantyProcedure for Obtaining Performance of Warranty