Poulan 96041007302, PP17538HP, 420408 Before Starting The Engine, Operation, To Operate On Hills

Page 13
TO OPERATE ON HILLS

OPERATION

TO TRANSPORT (See Figs. 5 and 13)WARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless absolutely necessary.

USING THE REVERSE OPERATION SYSTEM -

Only use if you are certain no children or other bystanders will enter the mowing area.

Depress brake pedal all the way down.

With engine running, turn ignition key counterclockwise to ROS "ON" position.

Look down and behind before and while backing.

Slowly depress reverse drive pedal to start move- ment.

When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position.

 

 

 

 

 

 

 

 

 

 

8

 

 

0282

ROS "ON" POSITION

ENGINE "ON" POSITION

 

 

(NORMAL OPERATING)

 

 

 

 

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

Choose the slowest speed before starting up or down hills.

Avoid stopping or changing speed on hills.

If stopping is absolutely necessary, push brake pedal quickly to brake position and engage parking brake.

To restart movement, slowly release parking brake and brake pedal.

Slowly depress appropriate drive pedal to slowest set- ting.

Make all turns slowly.

TO TRANSPORT (See Figs. 5 and 13)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

Raise attachment lift to highest position with attachment lift control.

Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

Do not push or tow tractor at more than two (2) MPH.

To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TRANSMISSION ENGAGED

TRANSMISSION DISENGAGED

FIG. 13

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

Check engine oil with tractor on level ground.

Pull up and remove oil fill cap/dipstick; wipe oil off. Reinsert the dipstick into the tube and push down firmly into place. Remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

To change engine oil, see the Maintenance section in this manual.

13

Image 13
Contents IMPORTANT MANUAL MODELDO NOT THROW AWAY OPERATORS MANUALSafe Operation Practices for Ride-On Mowers SAFETY RULESI. GENERAL OPERATION II. SLOPE OPERATIONIII. CHILDREN V. SERVICEIV. TOWING PRODUCT SPECIFICATIONS TABLE OF CONTENTSCUSTOMER RESPONSIBILITIES Steering Wheel UNASSEMBLED PARTSSeat 1 SeatTOOLS REQUIRED FOR ASSEMBLY ASSEMBLYTOREMOVETRACTORFROMCARTON BEFORE REMOVING TRACTOR FROM SKIDTO ADJUST SEAT See Fig INSTALL SEAT See FigPLEASE REVIEW THE FOLLOWING CHECKLIST CHECKLISTCHECK TIRE PRESSURE CHECK DECK LEVELNESSOPERATION HG DE KNOW YOUR TRACTORF K AC ML TO SET PARKING BRAKE See Fig HOW TO USE YOUR TRACTORSTOPPING TO USE THROTTLE CONTROL - D See FigTO ADJUST GAUGE WHEELS See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO OPERATE MOWER TO STOP MOWER BLADESTO OPERATE ON HILLS BEFORE STARTING THE ENGINETO TRANSPORT See Figs. 5 and CHECK ENGINE OIL LEVELTO START ENGINE See Fig ADD GASOLINEPURGE TRANSMISSION MOWING TIPS GENERAL RECOMMENDATIONS MAINTENANCEMAINTENANCE SCHEDULEBATTERY TRACTORBRAKE OPERATION TIRESCLEAN AIR SCREEN ENGINEV-BELTS TRANSAXLE COOLINGENGINE COOLING SYSTEM See Fig CLEANINGMUFFLER SPARK PLUGSTO INSTALL MOWER See Fig SERVICE AND ADJUSTMENTSTO REMOVE MOWER See Fig G MF RG QRepeat on opposite side of tractor G MF GTO LEVEL MOWER TO CHECK BRAKE TO REPLACE MOWER BLADE DRIVE BELT See FigTO REPLACE MOTION DRIVE BELT See Fig MANDRELIDLER PULLEYPULLEYS MANDREL PULLEYFRONT WHEEL TOE-IN/CAMBER TO START ENGINE WITH A WEAK BATTERY See FigTO REMOVE WHEEL FOR REPAIRS See Fig REPLACING BATTERY See Fig TRANSMISSIONTO REMOVE HOOD AND GRILL ASSEMBLY See Fig TO ADJUST THROTTLE CONTROL CABLEOTHER STORAGEFUEL SYSTEM ENGINE OILTROUBLESHOOTING POINTS TROUBLESHOOTING POINTS ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAX SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATIONSERVICE NOTES SERVICE NOTES 10.29.09 SR