Poulan 96041007302, PP17538HP, 420408 manual Assembly, INSTALL SEAT See Fig, TO ADJUST SEAT See Fig

Page 7
INSTALL SEAT (See Fig. 3 & 4)

ASSEMBLY

INSTALL SEAT (See Fig. 3 & 4)

•Remove bolt and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. Remove the cardboard packing and discard.

•Connect switch to seat.

•Place seat on seat pan so all three (3) bottom pads are positioned over large slotted holes in pan.

SEAT

SWITCH

PAD

SLOT

SEAT

PAN

TAPE

WIRING HARNESS

FIG. 3

•Push down on seat to engage pads in slots and pull seat towards rear of tractor.

•Raise seat and tighten bolt securely.

•Remove tape and discard.

•Lower seat into operating position and sit on seat. Press clutch/brake pedal all the way down. If operating position is not comfortable, adjust seat.

TO ADJUST SEAT (See Fig. 4)

•Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle.

SLOT

 

TAPE

PAD

 

 

FLAT

 

 

WASHER

 

 

SEAT PAN

 

BOLT

TAB

ADJUSTMENT

HANDLE

 

 

Fig. 4

NOTE: You may now roll your tractor off the skid. Follow the instructions below to remove the tractor from the skid.

TO ADJUST SEAT (See Fig. 4)WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Releaseparkingbrakebydepressingclutch/brakepedal.

•Place freewheel control in "transmission disengaged" position (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

Continue with the instructions that follow.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents OPERATORS MANUAL MODELIMPORTANT MANUAL DO NOT THROW AWAYII. SLOPE OPERATION SAFETY RULESSafe Operation Practices for Ride-On Mowers I. GENERAL OPERATIONIII. CHILDREN V. SERVICEIV. TOWING PRODUCT SPECIFICATIONS TABLE OF CONTENTSCUSTOMER RESPONSIBILITIES 1 Seat UNASSEMBLED PARTSSteering Wheel SeatBEFORE REMOVING TRACTOR FROM SKID ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY TOREMOVETRACTORFROMCARTONTO ADJUST SEAT See Fig INSTALL SEAT See FigCHECK DECK LEVELNESS CHECKLISTPLEASE REVIEW THE FOLLOWING CHECKLIST CHECK TIRE PRESSUREOPERATION HG DE KNOW YOUR TRACTORF K AC ML TO USE THROTTLE CONTROL - D See Fig HOW TO USE YOUR TRACTORTO SET PARKING BRAKE See Fig STOPPINGTO STOP MOWER BLADES TO ADJUST MOWER CUTTING HEIGHT See FigTO ADJUST GAUGE WHEELS See Fig TO OPERATE MOWERCHECK ENGINE OIL LEVEL BEFORE STARTING THE ENGINETO OPERATE ON HILLS TO TRANSPORT See Figs. 5 andTO START ENGINE See Fig ADD GASOLINEPURGE TRANSMISSION MOWING TIPS SCHEDULE MAINTENANCEGENERAL RECOMMENDATIONS MAINTENANCETIRES TRACTORBATTERY BRAKE OPERATIONTRANSAXLE COOLING ENGINECLEAN AIR SCREEN V-BELTSSPARK PLUGS CLEANINGENGINE COOLING SYSTEM See Fig MUFFLERG MF RG Q SERVICE AND ADJUSTMENTSTO INSTALL MOWER See Fig TO REMOVE MOWER See FigRepeat on opposite side of tractor G MF GTO LEVEL MOWER MANDRELIDLER PULLEYPULLEYS MANDREL PULLEY TO REPLACE MOWER BLADE DRIVE BELT See FigTO CHECK BRAKE TO REPLACE MOTION DRIVE BELT See FigFRONT WHEEL TOE-IN/CAMBER TO START ENGINE WITH A WEAK BATTERY See FigTO REMOVE WHEEL FOR REPAIRS See Fig TO ADJUST THROTTLE CONTROL CABLE TRANSMISSIONREPLACING BATTERY See Fig TO REMOVE HOOD AND GRILL ASSEMBLY See FigENGINE OIL STORAGEOTHER FUEL SYSTEMTROUBLESHOOTING POINTS TROUBLESHOOTING POINTS ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAX SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATIONSERVICE NOTES SERVICE NOTES 10.29.09 SR
Top Page Image Contents