Poulan 96041007302 manual Transmission, Service And Adjustments, Engine, REPLACING BATTERY See Fig

Page 25
REPLACING BATTERY (See Fig. 34)

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Fig. 34)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding.

Lift seat pan to raised position.

Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

Install new battery with terminals in same position as old battery.

First connect RED battery cable to positive (+) terminal with bolt and nut as shown. Tighten securely. Slide terminal cover over terminal.

Connect BLACK grounding cable to negative (-) ter- minal with remaining bolt and nut. Tighten securely.

Lower seat pan.

SEAT PAN

 

TERMINAL

NUT

COVER

BOLT

 

POSITIVE

NEGATIVE

(RED)

(BLACK)

CABLE

CABLE

02603

 

Fig. 34

TO REPLACE HEADLIGHT BULB

Raise hood.

Pull bulb holder out of the hole in the backside of the grill.

Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 35)

Raise hood.

Unsnap headlight wire connector.

Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

03075TO REPLACE HEADLIGHT BULB

FIG. 35

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engine manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

TRANSMISSION

REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and beforeoperating thetractor. See “PURGE TRANSMISSION” in the Operation section of this manual.

25

Image 25
Contents IMPORTANT MANUAL MODELDO NOT THROW AWAY OPERATORS MANUALSafe Operation Practices for Ride-On Mowers SAFETY RULESI. GENERAL OPERATION II. SLOPE OPERATIONIII. CHILDREN V. SERVICEIV. TOWING PRODUCT SPECIFICATIONS TABLE OF CONTENTSCUSTOMER RESPONSIBILITIES Steering Wheel UNASSEMBLED PARTSSeat 1 SeatTOOLS REQUIRED FOR ASSEMBLY ASSEMBLYTOREMOVETRACTORFROMCARTON BEFORE REMOVING TRACTOR FROM SKIDTO ADJUST SEAT See Fig INSTALL SEAT See FigPLEASE REVIEW THE FOLLOWING CHECKLIST CHECKLISTCHECK TIRE PRESSURE CHECK DECK LEVELNESSOPERATION HG DE KNOW YOUR TRACTORF K AC ML TO SET PARKING BRAKE See Fig HOW TO USE YOUR TRACTORSTOPPING TO USE THROTTLE CONTROL - D See FigTO ADJUST GAUGE WHEELS See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO OPERATE MOWER TO STOP MOWER BLADESTO OPERATE ON HILLS BEFORE STARTING THE ENGINETO TRANSPORT See Figs. 5 and CHECK ENGINE OIL LEVELTO START ENGINE See Fig ADD GASOLINEPURGE TRANSMISSION MOWING TIPS GENERAL RECOMMENDATIONS MAINTENANCEMAINTENANCE SCHEDULEBATTERY TRACTORBRAKE OPERATION TIRESCLEAN AIR SCREEN ENGINEV-BELTS TRANSAXLE COOLINGENGINE COOLING SYSTEM See Fig CLEANINGMUFFLER SPARK PLUGSTO INSTALL MOWER See Fig SERVICE AND ADJUSTMENTSTO REMOVE MOWER See Fig G MF RG QRepeat on opposite side of tractor G MF GTO LEVEL MOWER TO CHECK BRAKE TO REPLACE MOWER BLADE DRIVE BELT See FigTO REPLACE MOTION DRIVE BELT See Fig MANDRELIDLER PULLEYPULLEYS MANDREL PULLEYFRONT WHEEL TOE-IN/CAMBER TO START ENGINE WITH A WEAK BATTERY See FigTO REMOVE WHEEL FOR REPAIRS See Fig REPLACING BATTERY See Fig TRANSMISSIONTO REMOVE HOOD AND GRILL ASSEMBLY See Fig TO ADJUST THROTTLE CONTROL CABLEOTHER STORAGEFUEL SYSTEM ENGINE OILTROUBLESHOOTING POINTS TROUBLESHOOTING POINTS ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAX SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATIONSERVICE NOTES SERVICE NOTES 10.29.09 SR