ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(1) | 5/16" wrench | Utility knife |
(2) | 7/16" wrenches | Tire pressure gauge |
(2) | 1/2" wrenches | Pliers |
(1) | 9/16" wrench | (1) 3/4" wrench |
(1) | 3/4" socket with drive ratchet |
|
When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).
TOREMOVETRACTORFROMCARTON
UNPACK CARTON
•Remove all accessible loose parts and parts cartons from carton .
•Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat.
•Remove mower and packing materials.
•Check for any additional loose parts or cartons and remove.
BEFORE REMOVING TRACTOR FROM SKID
TO CHECK BATTERY (See Fig. 1)
•Lift seat to raised position.
NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at
•For battery and battery cable installation see "RE- PLACING BATTERY" in the "Service and Adjustments" section in this manual.
LABEL
TO INSTALL STEERING WHEEL (See Fig. 2)
ASSEMBLE EXTENSION SHAFT AND BOOT
•Slide extension shaft onto lower steering shaft.
•Place tabs of steering boot over tab slots in dash and push down to secure.
INSTALL STEERING WHEEL
•Position front wheels of the tractor so they are pointing straight forward.
•Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension.
•Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.
•Assemble large flat washer, lock washer, hex bolt and tighten securely.
•Snap steering wheel insert into center of steering wheel.
•Remove protective materials from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID.
STEERING
WHEEL
INSERT
BOLT
LOCKWASHER
LARGE FLAT
WASHER
STEERING
WHEEL
STEERING
BOOT
STEERING
WHEEL
ADAPTOR
EXTENSION
SHAFT
LOWER
STEERING
SHAFT
Fig. 1
Fig. 2
6