Scag Power Equipment SCR manual Maintenance Chart Recommended Service Intervals Contd

Section 7

MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)

	HOURS
Break-In 8	40 100 200 500			Procedure	Comments
(First 10)
		X		Apply grease to fittings	See paragraph 7.2
		X		Check hardware for tightness
		X		Change engine oil filter	See paragraph 7.4
		X		Check hydraulic oil level	See paragraph 7.3
			X	Replace engine fuel filter	See paragraph 7.5
			X	Drain hydraulic system and	See paragraph 7.3
				replace hydraulic oil	Use SAE 20W50
					Motor Oil
			X	Replace hydraulic oil filter	See paragraph 7.3
			X	Replace power unit gearbox	See paragraph 7.13
				lubricant
			X	Replace lubricant in cutter deck	See paragraph 7.12
				gear boxes
			X	*Check Clutch Air Gap	See your local Scag
					Dealer

*Perform these maintenance procedures more frequently under heavy load, extreme dusty or dirty conditions.

7.2 LUBRICATION

GREASE FITTING LUBRICATION CHART (SEE FIGURE 7-1)

		LUBRICATION		NO. OF
	LOCATION	INTERVAL	LUBRICANT	PLACES
1	Brake Linkage	100 Hours/Bi-Weekly	Chassis Grease	2
2	Caster Wheel Pivot	100 Hours/Bi-Weekly	Chassis Grease	2
3	Caster Wheel Bearings	100 Hours/Bi-Weekly	Chassis Grease	2
4	Cutter Deck Pivots	100 Hours/Bi-Weekly	Chassis Grease	2
5	Brake Lever	100 Hours/Bi-Weekly	Chassis Grease	1
6	Rear Wheel Bearings	100 Hours/Bi-Weekly	Chassis Grease	1
7	Cutter Deck Drive Shaft	100 Hours/Bi-Weekly	Chassis Grease	3
8	Steering Control Levers and Linkage	100 Hours/Bi-Weekly	Chassis Grease	4
9	Cutter Deck Spindles	40 Hours/Weekly	+Lithium MP White Grease 2125	3
10	Blower Bearing	8 Hours/Daily	+Lithium MP White Grease 2125	1

27