Scag Power Equipment STT-31BSD manual Maintenance Chart Recommended Service Intervals Contd

Section 7

MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)

	HOURS
Break-In 8	40 100 200 500			Procedure	Comments
(First 10)
		X		Apply grease to fittings	See paragraph 7.2
		X		Check hardware for tightness
		X		Change engine oil filter	See paragraph 7.4
		X		Check hydraulic oil level	See paragraph 7.3
			X	Replace engine fuel filter	See paragraph 7.5
			X	Drain hydraulic system and	See paragraph 7.3
				replace hydraulic oil	Use SAE 20W50
					Motor Oil
			X	Replace hydraulic oil filter	See paragraph 7.3
			X	Replace cutter deck gearbox lubricant	See paragraph 7.1
			X	Change coolant	See paragraph 7.12

7.2 LUBRICATION

GREASE FITTING LUBRICATION CHART (SEE FIGURE 7-1)

		LUBRICATION		NO. OF
	LOCATION	INTERVAL	LUBRICANT	PLACES
1	Caster Wheel Pivot	500 Hours/Yearly	Chassis Grease	2
2	Caster Wheel Bearings	100 Hours/Bi-Weekly	Chassis Grease	2
3	Brake Actuator	200 Hours/Monthly	Chassis Grease	2
4	Cutter Deck Bellcranks	40 Hours/Weekly	Chassis Grease	4
5	Cutter Deck Pusharms	100 Hours/Bi-Weekly	Chassis Grease	2
6	PTO Spindle	40 Hours/Weekly	+Lithium MP White Grease 2125	1
7	Cutter Deck Spindle	40 Hours/Weekly	+Lithium MP White Grease 2125	3
8	Brake Handle	200 Hours/Monthly	Chassis Grease	1
9	Cutter Deck Drive Shaft	40 Hours/Weekly	Chassis Grease	3
+	Compatible Greases:	Mobilix #2 found at Mobil Service Stations
		Ronex MP found at Exxon Service Stations
		Super Lube MEP #2 & Super Stay-M #2 found at Conoco Stations
		Shell Alvania #2 found at Shell Service Stations
		Lidok EP #2 found at industrial shops

29