Remington ST3812B, ST4514B owner manual Trimming Advancing Trimmer Line, Trimmer/Edger Operation

8 Chapter 4: Trimmer/Edger Operation

Trimming

Advancing Trimmer Line Replacing Trimmer/Edger Line

To reduce excessive line wear and improve trimming performance, follow the steps below to trim grass and weeds.

1.Remove any string, wire, or other ma- terials that could become entangled in the trimmer/edger from the trim- ming area.

2.Hold trimmer/edger using both front and rear handles (see Figure 4-11).

3.Slowly sweep the trimmer/edger from side to side or front to back.

4.Do not force the trimmer/edger. Al- low only the tip of the trimmer/edger line to cut the grass or weeds.

5.If grass or weeds are tall, cut them in several increments, starting from the top and working to the bottom.

WARNING: Blade is sharp. To prevent serious injury, do not touch blade.

To advance new trimmer/edger line,tap the line advance button on the ground while the trimmer/edger is running (see Figure 4-12). The blade attached to the cutting guard will cut the line to the proper length.

Follow the precautions below to ensure top line performance.

•Do not hold the line advance button on the ground. This will allow trim- mer/edger line to constantly feed off the spool.

•Tap the line advance button only once to advance line. If more line is needed, wait a few seconds and tap again.

•Be sure to advance the line as it wears down. If you wait too long to advance new line, the existing line will wear down too short and can retract into the spool. If this happens, remove the spool and reroute the line out of the spool. Reinstall the spool to the trim- mer/edger head.

Line

Advance

Button

Figure 4-12: Advancing trimmer/edger line

WARNING: To prevent serious personal injury, never use metal- reinforced line, wire, or rope, etc. These can break off and become a dangerous projectile.

CAUTION: Use of line other than specified could cause per- sonal injury or product failure.

For replacement line,use a nylon monofila- ment line of 0.065 inch in diameter. You can purchase replacement line at most lawn and garden stores.

Removing the Spool

1.Press in the two locking tabs holding the spool cover to the spool housing (see Figure 4-13).

2.Remove the spool cover and spool from spool housing (see Figure 4-14). Note: If spool spring comes off of spool housing, replace spring by placing the smaller end of spring into center of spool housing.Note: If install- ing replacement spool and line (P/N RS65B), skip to step 13, page 10.

3.Clean grass and other debris from the spool and spool housing using a brush (see Figure 4-15).

Figure 4-11: Holding trimmer/edger

Figure 4-13: Unlocking spool cover

118035