8. Operation
IMPORTANT
The oil flow adjusting screw must be pressed in slightly in order to turn. Failure
3.When starting to edge, run the engine at full throttle, and slowly have the blade cut into the edge groove.
to do so could damage the pump and screw.
(1) Direction of rotation
NOTE
U S
3.With a screwdriver, push in on the oil flow rate adjusting screw and turn in the desired direction (there are three incremental settings):
(a)
(b)Counter
(c)Middle
•Before edging, make sure the area is soft enough so the blade does not bog down.
•Do not move the edger into the work so fast that the engine or blade bogs down.
(RMS-EX only)
■BREAK-IN OPERATION
HE-EX2 OP1
WARNING
•Always wear work gloves made of leather or some other sturdy material when using the polesaw.
•Falling branches may fall onto the face or into the eyes, resulting in injuries, scratches, and cuts, and for this reason you should always be sure to wear a helmet and face protector when using your polesaw.
(HE-EX2 only)
WARNING
•Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury.
•Keep the blade guard and the mad guard attached in place at all times when the unit is operated.
•Before starting a job, check the area and remove all obstacles and objects that could be thrown by the blade.
•Do not adjust the wheel height or try to remove anything entangled to the blade with the engine running.
1.Before starting the engine, adjust the wheel height for desired cutting depth (See page 15).
2.Before starting a job, plan your direction of travel so that you can always hold the edger on you right side and can walk on a hard surface as much as possible.
RMS-EX OP1
The Properly Dressed Operator (OP1)
(1)ALWAYS wear hearing protective devices.
(2)ALWAYS wear eye protection such as goggles or safety glasses.
(3)ALWAYS wear a mask to protect against dust or other airborne particles.
(4)ALWAYS wear close fitting clothes. Gloves offer added protection and are strongly recommended. Do not wear clothing or jewelry that could get caught in machinery.
(5)ALWAYS wear leather or heavy- rubber shoes. NEVER work barefooted!
(6)BEWARE of thrown debris!
(7)DIRECTION OF ROTATION
•The RedMax Sweeper works best when its rubber fins can quickly slide or "skim" over the surface being swept.
•New or replacement sweeper belts tend to grip or drag on hard surfaces, and should be thoroughly broken in or "scuffed" before the broom is actually put to work.
•
•Experience will help you understand the operating principles of the RedMax Sweeper, but safe operation must be practiced from the start.