Ricoh NC5006 manual ~ Auto Reset, Set Operation Modes, Set Bypass Paper Size, Dual job feeder only

CHANGING DEFAULT SETTINGS

1~[ Auto Reset

Auto Reset

Screen Saver

SADF Auto reset

(for machine with

dual job feeder only)

The copier returns to its initial condition automatically after your job is finished, The automatic reset time can be set from 10 seconds to 900 seconds, or the function can be turned off.

Cl default: 60 sec.

When the machine does not detect anyone operating it for the selected time, the touch panel display turns off automatically. This time can be set from 10 seconds to 900 seconds, or the function can be turned off.

Q default: OFF

In the SADF mode (Semi-Automatic Document Feed mode U=page 4-6 “Setone C)riginal At A Time”)? if the next original is not set within the selected time, the machine will cancel the Semi-Automatic Document Feed mode automatically. The SADF Auto reset time can be set from 1 to 99 seconds, or the function can be turned off.

Cl default: 5 sec.

[ 2 [ Set Operation Modes

Maximum	copy input	The maximum copy quantity can be set from 1 to 99.
number		~ default: 99
		In the default setting, narrow margins on all four sides will not be copied
		as shown in the illustration.

3 Side Full Image

Auto Tray Switching

Panel beeper

Editor Grid Display (for machine with display editor only)

OFF ~ Paper feed direction ON

D default: OFF

Cl You cannot cancel the leading edge margin.

If you load paper of the same size and in the same direction in two or more paper trays, the machine automatically shifts to another tray when the tray in use runs out of paper.

Q default: ON

Cl By-pass feed tray cannot be used for Auto Tray Shifting,

The bee er (key tone) can be set to on or off.

Cl defau Pt: ON

You can set the grid snap on or off in the display editor. The rids ma help you to mark a right angle shape. Lld#ault: O#F

I 3 I Set Bypass Paper Size

If you load non-standard paper in the by-pass feed tray, the machine cannot detect the paper size and direction and the copied image might not be correctly positioned on the copy paper. One non-standard paper size and direction data is always specified in the user tool, and if the non-standard paper size you are going to use is different from this, change the paper size and direction data with this user tool to make a correct copy. (Horizontal direction: 148-432

mm or 5.8”- 17.0”,Vertical direction: 100-297 mm or 3.9”-11.7” )

8-3