Ricoh NC5006 manual Setting Paper on the BY-PASS Feed Tray, Insert the paper until it stops

SETTING PAPER ON THE BY-PASS FEED TRAY

SETTING PAPER ON THE BY-PASS FEED TRAY

~Before setting the copy paper, read page 5-6 for detailed information about by-pass feed copying.

+Check if the copy paper is suitable for by-passfeed copying.

+Check which keys should be selected to match the copy paper type.

Cl Before setting the copy paper, refer to the “useOf Copy Paper” (page 3-2) for non-recom- mended types of paper.

1.Push on the upper left corner of by- pass feed tray. The by-pass feed tray will open.

2.Adjust the paper guides to match the paper size and direction.

0If the paper guides do no match the paper width, the copy paper may be misfed or skewed.

CJ If you use large copy paper such as A3 or 11” x 17“size paper, pull out the paper support guide.

3. Insert the paper until it stops.

IJ Make sure to read the notice on the pack- age showing the front side (copy side) of the paper. Load paper with the copy side Up.

~Do not stack paper over the limit mark.

~If copying on adhesive labels, insert one sheet at a time.

3-6