Simplicity 5022285, CE Models Control Functions, Parking Brake, Choke, PTO Power Take Off Switch

Page 14

Features & Controls

Figure 1. Control Locations

CONTROL FUNCTIONS

The information below briefly describes the function of individual controls. Starting, stopping, driving, and mowing require the combined use of several controls applied in specific sequences. To learn what combination and sequence of controls to use for various tasks see the OPERATION section.

Deck Lift Pedal, Cutting Height Adjustment Pin & Deck Lift Lock Lever

These control the cutting height of the mower deck. Depress the pedal until it locks into the 5” (12,7 cm) position. Place the adjustment pin in the desired cutting height and release the lift lock lever.

Parking Brake

DISENGAGE	Releases the parking brake.
ENGAGE	Locks the parking brake.

Pull the parking brake lever back to engage the

parking brake. Move the lever fully forward to disengage the parking brake. NOTE: To start the unit the parking brake must be engaged.

Choke

Close the choke for cold starting. Open the choke once the engine starts. A warm engine may not require choking. Pull the knob UP to close the choke. Push to knob DOWN to open the choke.

PTO (Power Take Off) Switch

The PTO switch engages and disengages the mower. Pull UP on the switch to engage, and push DOWN to disengage.

10

Image 14

Contents Press Operator’s ManualsPaper Size BinderyPage 21HP Zero-Turn Riders 23HP Zero-Turn RidersPage Table of Contents Transporting and Storage Safety Rules and InformationGeneral Operation Emissions Slope OperationChildren Towed Equipment RIDE-ON UnitsSafe Handling of Gasoline Service and MaintenanceService & Maintenance Safety Rules & Information Roll BAR InstructionsInspection and Maintenance of the Roll BAR Seat Belt North American Identification Numbers CE Identification TAG Markings CE ModelsDecal Danger, Mower Decal MainPart No Safety DecalsSafety Decals Decal Warning Part NoOperational Safety Checks Safety Icons & Interlock SystemSafety Interlock System Parking Brake PTO Power Take Off SwitchControl Functions ChokeFeatures & Controls General Operating Safety Checks Before StartingStopping the Rider OperationStarting the Engine MowingForward Travel Practice Zero Turn Driving PracticeSmooth Travel Reverse Travel PracticeExecuting Turns Practice Turning Around a Corner Practice Turning In PlaceExecuting an End-Of-Row Zero Turn To raise the roll bar Raise & Lower the Roll BARTo lower the roll bar Keep roll bar in the raised position and use seat beltAttaching a Trailer StorageEngine Maintenance Safety ItemsRider Maintenance Before Every Spring Each 100 250 Fall Use HoursRegular Maintenance Oil LubricationGrease Check Hydraulic OIL Level Battery MaintenanceCleaning the Battery and Cables Change Hydraulic OIL FilterServicing the Mower Blades Removing the BladeTroubleshooting Adjustments & Service Troubleshooting the RiderTroubleshooting, Adjustment & Service Troubleshooting the MowerSpeed Balancing Adjustment Seat AdjustmentGround Speed Control Lever Adjustment Parking Brake Adjustment Battery ChargingTo adjust the upper mounting position Rear Suspension AdjustmentTo adjust the spring pre-load PTO Clutch Adjustment Blade Brake CheckAdjustment RETURN-TO-NEUTRAL AdjustmentNeutral Adjustment To adjust pedal position Mowing Height AdjustmentFoot Pedal Adjustment Deck Leveling Adjustment 4 SpacersHydraulic Pump Drive Belt Replacement Mower Belt Replacement Mower PTO Belt Idler Arm Stationary Idler PulleyChassis DimensionsEngine Transmissions