Homelite UT32650 Operation, Front handle, String Head Assembly, Curved shaft Grass Deflector 26cs

Page 10

ASSEMBLY

Front handle

See Figure 2.

Loosen and remove the wing nut, washer, and bolt from the handle.

Install the handle on the drive shaft housing at the loca- tion indicated by the label on the shaft.

Adjust handle up or down, if necessary, to desired operat- ing position.

Reinstall the bolt, washer, and wing nut. Tighten wing nut to secure.

NOTE: On units with curved shafts, for shipping purposes only, the handle is located underneath the drive shaft housing. The handle must be rotated before operating the trimmer.

Slightly loosen the wing nut on the handle.

Rotate the handle on the drive shaft housing at the loca- tion indicated by the label on the shaft.

Retighten the wing nut to secure the handle in place.

STRING HEAD ASSEMBLY

See Figures 3 - 4.

Place the string head assembly on the end of the drive shaft. Make sure the hex-shaped opening on the string head assembly seats completely on the drive shaft. Install the spool retainer to secure.

Install the spool retainer:

Turn the spool retainer clockwise for 26CS.

Turn the spool retainer counterclockwise for 26SS.

Remove the plastic seal from the string head assembly. Pull outward on the strings to rotate the spool into the cutting position.

Push the spool retainer down while pulling on string(s) to manually advance the string and to check for proper assembly of the string head.

curved shaft GRASS DEFLECTOR – 26cs

See Figure 5.

WARNING:

The line cutting blade on the grass deflector is sharp. Avoid contact with the blade. Failure to avoid contact can result in serious personal injury.

Remove the bolt, washer, and wing nut from grass deflector.

Press the grass deflector onto the bottom of the curved shaft as shown.

Insert the bolt through the grass deflector and the bracket on the curved shaft.

Place the washer on the bolt.

Place the wing nut on the bolt and tighten securely.

straight shaft GRASS DEFLECTOR – 26ss

See Figure 6.

Remove the wing nut and mounting bracket from the grass deflector.

Assemble straight shaft grass deflector to drive shaft so that the pin in the grass deflector fits in the locator hole in the lower side of the drive shaft near the gear head.

Place the mounting bracket over the drive shaft so the square tab on the mounting bracket fits into the slot in the straight shaft grass deflector.

Rotate the mounting bracket so the screw on the grass deflector goes into the slot on the mounting bracket.

Reinstall the wing nut and tighten securely.

OPERATION

WARNING:

Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to comply with ANSI Z87.1, along with hearing protection. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries.

WARNING:

Never use blades, flailing devices, wire, or rope on this prod- uct. Do not use any attachments or accessories not rec- ommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury.

Before each use, inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or damaged parts are replaced. Please call 1-800-242-4672 or contact an authorized service center for assistance.

Page 6 — English

Page 9 Page 11
Image 10
Page 9 Page 11
Contents ALL Versions Manuel D’UTILISATION Manual DEL OperadorSave this Manual for Future Reference Toutes LES VersionsPage 26CS 26ssProper operating Tapa del filtro de aire Table of Contents Specific Safety Rules General Safety RulesRead all instructions Symbols Symbol Signal MeaningAssembly Front handle String Head AssemblyOperation Curved shaft Grass Deflector 26csOxygenated Fuels Fueling and Refueling the trimmerFuel Mixture Filling TankCutting Tips Advancing String Using the reel-EASYTap Advance SystemOperating the Trimmer Advancing the String ManuallyMaintenance Fuel CAP TroubleshootingWhen storing 1 month or longer Spark PlugProblem Possible Cause Solution Air Filter Screen earlier in thisWarranty Limited Warranty Statement13 English AIR Filter Assy Emissions Maintenance Schedule and Warranted Parts ListThis product was manufactured with a catalyst muffler Fuel Tank AssyAVERTISSEMENT  Règles DE Sécurité GénéralesRègles DE Sécurité Particulières Lire Toutes LES InstructionsExplication SymbolesSymbole Nom 4 FrançaisAssemblage Déflecteur D’HERBE Pour Arbre Droit UtilisationAvertissement Avertissement AVERTISSEMENT Remplissage DU Réservoir Approvisionnement EN Carburant Mélange DE CarburantCarburants Oxygénés Démarrage ET ArrêtAvance Manuelle DE LA Ligne DE Coupe Utilisation DU TAILLE-BORDURESAconseils DE Coupe Lame Coupe LigneEntretien Bougie DépannageBouchon DU Réservoir DE Carburant AVERTISSEMENT  Remisage du taille-borduresNettoyage du filtre à air , plus haut Rebobiner. Voir Remplacement de la11 Français Déclaration DE Garantie Limitée Garantie12 Français 13 Français Durée DE LA Garantie DU Fabricant’AIDE? 14 FrançaisAdvertencia Reglas DE Seguridad GeneralesReglas DE Seguridad Específicas Lea todas las instruccionesPrecaución SímbolosPeligro Página 4 EspañolCaracterísticas ArmadoDeflector DE Pasto del eje curvo 26cs FuncionamientoConjunto del cabezal del hilo Deflector de pasto del eje recto 26ssArranque Y Apagado Mezcla DE CombustibleLlenado DEL Tanque Combustible AceiteAvance Manualmente EL Hilo Manejo DE LA RecortadoraConsejos Para Recortar Cuchilla DE Corte DEL HiloMantenimiento Bujía Corrección DE ProblemasTapa DEL Tanque DE Combustible Advertencia Almacenamiento de la recortadoraReabastecimiento del hilo arriba en Página 11 EspañolDeclaración DE LA Garantía Limitada GarantíaPágina 12 Español Garantía Página 13 EspañolEste producto se fabricó con un silenciador catalítico Página 14 EspañolPage Manuel D’UTILISATION Manual DEL Operador OPERATOR’S Manual26CS UT32600 26SS UT32650

UT32600, UT32650 specifications

The Homelite UT32650 and UT32600 are standout gas-powered string trimmers designed to meet the needs of both amateur gardeners and seasoned landscapers. These models are primarily recognized for their robust performance, user-friendly features, and innovative technologies that enhance the overall trimming experience.

One of the standout features of the UT32650 and UT32600 is their lightweight design, which allows for easy maneuverability and reduces user fatigue during extended use. This is particularly important for homeowners and landscape professionals who need to tackle large properties or long hours of work. The ergonomic handle provides a comfortable grip, further enhancing user comfort.

Both models are powered by dependable 26cc two-cycle engines, delivering impressive cutting power while remaining relatively fuel-efficient. This power enables users to handle tougher weeds and brush with relative ease, making them ideal for diverse cutting activities. The easy-start technology incorporated into these trimmers simplifies the ignition process, reducing the hassle associated with starting gas-powered tools.

Another key feature is the automatic line advancement system, which ensures that the cutting line is always exposed at the optimal length for efficient trimming. This automatic feed reduces downtime, allowing users to focus on the task at hand without the need for frequent manual adjustments. The dual-line cutting head is designed to deliver a clean and precise cut, promoting a healthier lawn.

The UT32650 and UT32600 also boast a robust construction that can withstand the rigors of outdoor use. The durable materials used in their manufacturing ensure longevity and reliability, which is essential for any professional tool. Moreover, these models come with adjustable shaft lengths, allowing users to customize the tool to their height for an improved working posture.

In summary, the Homelite UT32650 and UT32600 string trimmers combine lightweight design, potent two-cycle engines, and user-friendly features to create a powerful and efficient gardening tool. With their innovative technologies, including easy start systems and automatic line feeding, they make lawn care simpler and more effective. Whether for residential maintenance or professional landscaping tasks, these trimmers are equipped to handle a variety of challenges, ensuring that your outdoor spaces remain well-manicured and beautiful.
Top Page Image Contents