Husqvarna 335FR manual Assembly, Rx,Fr R, Assembling the handlebar and throttle

Page 13

ASSEMBLY

Assembling the handlebar and throttle

•Remove the screw at the rear of the throttle handle.

•Slide the throttle handle onto the right side of the handlebar, (see diagram).

•Align the screw hole in the throttle handle with the hole in the handlebar.

•Refit the screw in the hole in the rear of the throttle handle.

•Screw the screw through the handle and handlebar. Tighten it.

RX,FR R

•Fit the mounting components as shown.

•Loosely tighten the four screws. (R)

•Put on the harness and hang the machine from the support hook. Now make a final adjustment so that the machine is in a comfortable working position when it hangs from the harness.

•Tighten the knob. (FR, RX)

Assembling the cutting equipment

WARNING!

! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting

! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

Fitting the guard extension

CAUTION! The guard extension shall always be fitted when using the trimmer head/plastic blades and combination guard. The guard extension shall always be removed when using the grass blade and combination guard.

Enter the guard extension guide in the slot of the combination guard. Then click the guard extension into position on the guard with the four quick-fasteners.

English – 13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 333R 335FR 335RX-series Symbols KEY to SymbolsOperator of the machine must Ensure, while working, that no Persons or animals come closer thanContents Dear customer IntroductionWhat is what on the clearing saw? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentCutting attachment guard Stop switchVibration damping system 335RX, 335FRMuffler Locking nut Cutting equipmentCutting equipment General rulesSharpening the saw blade Sharpening grass cutters and grass bladesTrimmer head RX,FR R AssemblyAssembling the handlebar and throttle Assembling the cutting equipmentFitting the blade guard and saw blade Fitting a blade guard, grass blade and grass cutterFitting other guards and cutting attachments Shielded by the blade guard when doing this. AlwaysStandard harness Adjusting the harness and clearing sawTriobalance harness Correct balance Fuel Handling Fuel safetyFuel Mixing FuelingCheck before starting Starting and StoppingStarting and stopping StartingStopping For throttle handles with a start throttle lockStarter cord around your hand Working Techniques Basic safety rulesGeneral working instructions ABC of clearingForestry clearing using a saw blade Brush cutting with a saw blade Grass trimming with a trimmer head Grass clearing using a grass bladeCarburetor MaintenanceCorrectly adjusted carburetor Fine adjustment of the idle speed TLow speed jet L High speed jet HMuffler Adjusting the start throttle speedCooling system Cleaning the air filterBevel gear Air filterSpark plug Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Auto Trimmy SII Page 1151115-95
Top Page Image Contents