Husqvarna 335FR manual Starting and Stopping, Check before starting, Starting and stopping

Page 20

STARTING AND STOPPING

Check before starting

•Check the blade to ensure that no cracks have formed at the bottom of the teeth or by the centre hole. The most common reason why cracks are formed is that sharp corners have been formed at the bottom of the teeth while sharpening or that the blade has been used with dull teeth. Discard a blade if cracks are found.

•Check that the support flange is not cracked due to fatigue or due to being tightened too much. Discard the support flange if it is cracked.

•Ensure the locking nut has not lost its captive force. The nut lock should have a locking force of at least 1.5 Nm. The tightening torque of the locking nut should be 35-50 Nm.

•Check that the blade guard is not damaged or cracked. Replace the blade guard if it is exposed to impact or is cracked.

•Check that the trimmer head and trimmer guard are not damaged or cracked. Replace the trimmer head or

trimmer guard if they have been exposed to impact or are cracked.

•Never use the machine without a guard nor with a defective guard.

•All covers must be correctly fitted and undamaged before you start the machine.

Starting and stopping

WARNING! The complete clutch cover

!and shaft must be fitted before the machine is started, otherwise the clutch can come loose and cause personal injury.

Always move the machine away from the refuelling area before starting. Place the machine on a flat surface. Ensure the cutting attachment cannot come into contact with any object.

Make sure no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury.The safety distance is 15 metres.

Starting

Choke: Set the choke control in the choke position.

20 – English

Page 19 Page 21
Image 20
Page 19 Page 21
Contents 333R 335FR 335RX-series KEY to Symbols SymbolsOperator of the machine must Ensure, while working, that no Persons or animals come closer thanContents Introduction Dear customerWhat is WHAT? What is what on the clearing saw?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system 335RX, 335FRMuffler Cutting equipment Locking nutCutting equipment General rulesSharpening grass cutters and grass blades Sharpening the saw bladeTrimmer head Assembly RX,FR RAssembling the handlebar and throttle Assembling the cutting equipmentFitting a blade guard, grass blade and grass cutter Fitting the blade guard and saw bladeShielded by the blade guard when doing this. Always Fitting other guards and cutting attachmentsTriobalance harness Adjusting the harness and clearing sawStandard harness Correct balance Fuel Fuel safetyFuel Handling Fueling MixingStarting and Stopping Check before startingStarting and stopping StartingStarter cord around your hand For throttle handles with a start throttle lockStopping Basic safety rules Working TechniquesGeneral working instructions ABC of clearingForestry clearing using a saw blade Brush cutting with a saw blade Grass clearing using a grass blade Grass trimming with a trimmer headMaintenance CarburetorFine adjustment of the idle speed T Correctly adjusted carburetorLow speed jet L High speed jet HAdjusting the start throttle speed MufflerCleaning the air filter Cooling systemBevel gear Air filterSpark plug Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Auto Trimmy SII Page 1151115-95
Top Page Image Contents