Husqvarna 335FR Adjusting the harness and clearing saw, Standard harness, Triobalance harness

Page 16

ASSEMBLY

Adjusting the harness and clearing saw

WARNING! When using a clearing saw it

! must always be hooked securely to the harness. Otherwise you will be unable to control the clearing saw safely and this can result in injury to yourself or others. Never use a harness with a defective quick release.

Standard harness

Quick release

At the front is an easily accessible, quick release. Use this if the engine catches ﬁre or in any other emergency situation that requires you to free yourself from the machine and harness.

Spreading the load on your shoulders

A well-adjusted harness and machine makes work much easier. Adjust the harness for the best working position. Tension the side straps so that the weight is evenly distributed across both shoulders.

Correct height

1Forestry clearing

The machine should be supported in a harness when forestry clearing so that the cutting equipment is angled slightly forwards in relation to the ground. Adjust the

height using the strap on the harness for the support hook.

2Grass clearing

The machine should be supported in a harness when grass clearing so that the cutting equipment is parallel to the ground.

Triobalance harness

Quick release

Push down the red release lever to release the machine from the harness.

Adjusting the harness

1 Tighten the hip strap so that it sits securely.

16 – English

Image 16

Contents 333R 335FR 335RX-series KEY to Symbols SymbolsOperator of the machine must Ensure, while working, that no Persons or animals come closer thanContents Introduction Dear customerWhat is WHAT? What is what on the clearing saw?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system 335RX, 335FRMufﬂer Cutting equipment Locking nutCutting equipment General rulesSharpening grass cutters and grass blades Sharpening the saw bladeTrimmer head Assembly RX,FR RAssembling the handlebar and throttle Assembling the cutting equipmentFitting a blade guard, grass blade and grass cutter Fitting the blade guard and saw bladeShielded by the blade guard when doing this. Always Fitting other guards and cutting attachmentsStandard harness Adjusting the harness and clearing sawTriobalance harness Correct balance Fuel Handling Fuel safetyFuel Fueling MixingStarting and Stopping Check before startingStarting and stopping StartingStopping For throttle handles with a start throttle lockStarter cord around your hand Basic safety rules Working TechniquesGeneral working instructions ABC of clearingForestry clearing using a saw blade Brush cutting with a saw blade Grass clearing using a grass blade Grass trimming with a trimmer headMaintenance CarburetorFine adjustment of the idle speed T Correctly adjusted carburetorLow speed jet L High speed jet HAdjusting the start throttle speed MufﬂerCleaning the air ﬁlter Cooling systemBevel gear Air ﬁlterSpark plug Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Auto Trimmy SII Page 1151115-95