Husqvarna 335FR manual Fitting a blade guard, grass blade and grass cutter

Page 14

ASSEMBLY

The guard extension is removed easily using the spark plug spanner, see illustration.

Fitting a blade guard, grass blade and grass cutter

G

F

E

D

B

AC

A

Hook the blade guard/combination guard (A) onto the fitting on the shaft and secure with the bolt. CAUTION! Ensure that the guard extension is removed.

Use the recommended blade guard. See the Technical data section.

Fit the drive disc (B) on the output shaft.

Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

Insert the locking pin (C) in the hole to lock the shaft.

Place the blade (D), support cup (E) and support flange (F) on the output shaft.

Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn

the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).

Fitting the blade guard and saw blade

K

J

H

I

A

L

Remove the mounting plate (H). Fit the adapter (I) and bracket (J) with the two screws (K) as shown. Fit the blade guard (A) to the adapter using the 4 screws (L) as shown.

CAUTION! Use the recommended blade guard. See the Technical data section.

G

F

D

B

C

Fit the drive disc (B) on the output shaft.

Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

14 – English

Image 14
Contents 333R 335FR 335RX-series Operator of the machine must Ensure, while working, that no KEY to SymbolsSymbols Persons or animals come closer thanContents Introduction Dear customerWhat is WHAT? What is what on the clearing saw?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchCutting attachment guard 335RX, 335FRMuffler Cutting equipment Cutting equipmentLocking nut General rulesSharpening grass cutters and grass blades Sharpening the saw bladeTrimmer head Assembling the handlebar and throttle AssemblyRX,FR R Assembling the cutting equipmentFitting a blade guard, grass blade and grass cutter Fitting the blade guard and saw bladeShielded by the blade guard when doing this. Always Fitting other guards and cutting attachmentsTriobalance harness Adjusting the harness and clearing sawStandard harness Correct balance Fuel Fuel safetyFuel Handling Fueling MixingStarting and stopping Starting and StoppingCheck before starting StartingStarter cord around your hand For throttle handles with a start throttle lockStopping General working instructions Basic safety rulesWorking Techniques ABC of clearingForestry clearing using a saw blade Brush cutting with a saw blade Grass clearing using a grass blade Grass trimming with a trimmer headMaintenance CarburetorLow speed jet L Fine adjustment of the idle speed TCorrectly adjusted carburetor High speed jet HAdjusting the start throttle speed MufflerBevel gear Cleaning the air filterCooling system Air filterSpark plug Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Auto Trimmy SII Page 1151115-95