Husqvarna 335FR manual Brush cutting with a saw blade

Page 24

WORKING TECHNIQUES

the same time push the stem using the blade guard. Cut with the area of the blade between 3 o’clock and 5 o’clock. Apply full throttle before advancing the blade.

•To fell to the right, the bottom of the tree should be pushed to the left. Tilt the blade and bring it diagonally up to the right. Cut with the area of the blade between 3 o’clock and 5 o’clock so that the direction of rotation of the blade pushes the bottom of the tree to the left.

•To fell a tree forwards, the bottom of the tree should be pulled backwards. Pull the blade backwards with a quick, firm movement.

•Large stems must be cut from two sides. First determine which direction the stem will fall. Make the first cut on the felling side. Then finish cutting the stem from the other side. Adjust the cutting pressure to match the size of the stem and the hardness of the

wood. Small stems require more pressure, while large stems require less pressure.

•If the stems are tightly packed, adapt your walking pace to suit.

•If the blade jams in a stem, never jerk the machine free. If you do this the blade, bevel gear, shaft or handlebar may be damaged. Release the handles, grip the shaft with both hands and gently pull the machine free.

Brush cutting with a saw blade

•Thin stems and brush are mown down. Work with a sawing movement, swinging sideways.

•Try to cut several stems in a single sawing movement.

•With groups of hardwood stems, first clear around the group. Start by cutting the stems high up around the outside of the group to avoid jamming. Then cut the stems to the required height. Now try to reach in with the blade and cut from the centre of the group. If it is still difficult to gain access, cut the stems high up and let them fall. This will reduce the risk of jamming.

24 – English

Page 23 Page 25
Image 24
Page 23 Page 25
Contents 333R 335FR 335RX-series KEY to Symbols SymbolsOperator of the machine must Ensure, while working, that no Persons or animals come closer thanContents Introduction Dear customerWhat is WHAT? What is what on the clearing saw?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system 335RX, 335FRMuffler Cutting equipment Locking nutCutting equipment General rulesSharpening grass cutters and grass blades Sharpening the saw bladeTrimmer head Assembly RX,FR RAssembling the handlebar and throttle Assembling the cutting equipmentFitting a blade guard, grass blade and grass cutter Fitting the blade guard and saw bladeShielded by the blade guard when doing this. Always Fitting other guards and cutting attachmentsAdjusting the harness and clearing saw Standard harnessTriobalance harness Correct balance Fuel safety Fuel HandlingFuel Fueling MixingStarting and Stopping Check before startingStarting and stopping StartingFor throttle handles with a start throttle lock StoppingStarter cord around your hand Basic safety rules Working TechniquesGeneral working instructions ABC of clearingForestry clearing using a saw blade Brush cutting with a saw blade Grass clearing using a grass blade Grass trimming with a trimmer headMaintenance CarburetorFine adjustment of the idle speed T Correctly adjusted carburetorLow speed jet L High speed jet HAdjusting the start throttle speed MufflerCleaning the air filter Cooling systemBevel gear Air filterSpark plug Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Auto Trimmy SII Page 1151115-95
Top Page Image Contents