Adjustment of cutting angle
1.Stop the pole hedge trimmer engine and lay the machine on the ground.
2.To adjust the angle of the cutter unit, loosen the clamp lever located at the top of the cutter unit by turning it
3.Adjust the angle of the cutter unit and turn the clamp lever clockwise to secure.
•The cutter unit can be adjusted anywhere between 45° and 90°.
Note:
Tighten
Clamp lever
-Do not adjust the cutter unit while the pole hedge trimmer is in an upright position.
-Move the
-Always secure the blades with the blade cover provided before adjusting cutting angle.
Loosen
MAINTENANCE
-Before performing any maintenance work on the pole hedge cutter (blade cleaning, etc.), always stop the engine and wait until the engine has cooled down. As an additional safety precaution, also remove the spark plug cap.
-Do not try to straighten or weld a bent or broken cutting blade. Always replace damaged blades.
-Stop the engine at regular intervals to check the cutter blades for possible damage (perform a
-Clean the pole hedge trimmer at regular intervals. During cleaning also check that all screws, nuts and bolts are well tightened.
-To reduce the risk of fire, never service or store the pole hedge trimmer in the vicinity of open fires.
-Always wear rugged protective gloves when handling the cutter blades.
-Contact your dealer for replacement cutter blades.
Sharpening the blade
If the cutting blades have become blunt and cutting performance is poor, have the blades sharpened by an authorized service agent.
14