Snapper CRP216019KWV important safety instructions Snapper Product Registration Form

Page 28

SNAPPER PRODUCT REGISTRATION FORM

SNAPPER PRODUCT REGISTRATION FORM

IMPORTANT: KEEP THIS INFORMATION FOR YOUR PERSONAL RECORDS

(Complete the following information on your Snapper purchase)

Model Number_____________________________________________________________

Serial Number _____________________________________________________________

Date of Purchase ___________________________________________________________

Retailer____________________________________________________________________

Retailer’s Phone Number ____________________________________________________

It is very important that you register your purchase with Snapper to ensure warranty coverage. Please mail your product registration card to:

Snapper at P.O. Box 777, McDonough, Georgia 30253.

Or you may register on line at www.snapper.com.

You can contact us at our web site or if you would like to speak with a Customer Service Representative. Call us at the Snapper Customer Relations Center. For faster service please have your Serial Number and Model Number available.

Call the Snapper Customer Relations Center at 1-800-935-2967.

28

Image 28

Contents Safety Instructions & Operator’s Manual for 21” STEEL DECK RECYCLING WALK MOWERS COMMERCIAL MODELS SERIESPROPELLED MODELS CRP216019KWVIMPORTANT SAFETY INSTRUCTIONS PROTECTION FOR CHILDRENSLOPE OPERATION PREPARATIONMAINTENANCE AND STORAGE OPERATIONIMPORTANT SAFETY INSTRUCTIONS TABLE OF CONTENTS Section 1 - FAMILIARIZATION ENGINE SPEED CONTROL1.1 INTRODUCTION 1.2 NOMENCLATURE2.1 PRE-START CHECK LIST Section 2 - OPERATING INSTRUCTIONS2.2 STARTING & OPERATION 2.2.1. ENGINE & BLADE 2.2.3. PROPELLING MOWER 2.7 INSTALLATION OF SIDE DISCHARGE DEFLECTOR 2.6 RECYCLING OPERATIONTO REMOVE RECYCLING COVER Continued Next PageREPLACEMENT ROUTE RECOIL ROPE AROUND PULLEY SECURE ADAPTER TO DECKBOLT WITH THREAD SLEEVE1. Grasp bag connector and bag handle as shown. See Figure Section 3 - MAINTENANCE IMPORTANT Drain fuel tank before tipping mower Section 4 - REPAIR & ADJUSTMENTS 4. Sharpen blade on a grinding wheel at an angle of 1. Grease on drive disc causing slippage 7. Reinstall driven disc spring to driven disc assembly BEARING REMOVE FOURMACHINE SCREWSTo replace the bearing on the pulley end of the hex Remove the driven disc. Refer to Section TROUBLESHOOTING PROBLEMPROBABLE CAUSE CORRECTIVE ACTIONSERVICE SCHEDULE MAINTENANCE PARTS2 YEAR LIMITED WARRANTY PRIMARY MAINTENANCE PRIMARY MAINTENANCE PRIMARY MAINTENANCE PRIMARY MAINTENANCE SNAPPER PRODUCT REGISTRATION FORM Page Page Page Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and critical safety warnings. Read, Understand, and Follow all warnings and instructions in this manual, the engine manual, and on the machine, engine and attachments. If you have any questions about your Snapper product, contact your local authorized Snapper dealer or contact Snapper Customer Service at Snapper, McDonough, GA. 30253. Phone