Snapper CRP216019KWV Familiarization, Engine Speed Control, Introduction, Nomenclature

Page 6

Section 1 - FAMILIARIZATION

Section 1 - FAMILIARIZATION

BLADE

CONTROL

GROUND SPEED

CONTROL

WHEEL DRIVE

CONTROL

ENGINE

SPEED

CONTROL

ROPE	OIL FILL
START	AND DIPSTICK
HANDLE

FUEL FILL

REAR HEIGHT

ADJUSTMENT

LATCH

RECYCLING

COVERFRONT HEIGHT

ADJUSTMENT

LATCHES

ENGINE

SPEED

CONTROL

CHOKE

FAST

SLOW

FIGURE 1.1

1.1 INTRODUCTION

This manual has been prepared for the operators of the SNAPPER WALK BEHIND MOWERS. Its purpose, aside from recommending operating and routine service requirements, is to promote safety through the use of accepted operating practices. Read, Understand and Follow the “IMPORTANT SAFETY INSTRUCTIONS” on Pages 2 - 4 of this manual and all safety messages on the mower and attachments before operating the mower.

1.2 NOMENCLATURE

The nomenclature drawing above, Figure 1.1, shows the essential parts of the SNAPPER WALK BEHIND MOWERS. It is recommended that all operators of the mower become thoroughly familiar with the controls, parts and operation of the mower before operating. Specific details involving the engine are found in the separate engine owner’s manual. Study these manuals before operating and keep both handy for future reference.

6

Image 6

Contents PROPELLED MODELS Safety Instructions & Operator’s Manual for21” STEEL DECK RECYCLING WALK MOWERS COMMERCIAL MODELS SERIES CRP216019KWVSLOPE OPERATION IMPORTANT SAFETY INSTRUCTIONSPROTECTION FOR CHILDREN PREPARATIONMAINTENANCE AND STORAGE OPERATIONIMPORTANT SAFETY INSTRUCTIONS TABLE OF CONTENTS 1.1 INTRODUCTION Section 1 - FAMILIARIZATIONENGINE SPEED CONTROL 1.2 NOMENCLATURESection 2 - OPERATING INSTRUCTIONS 2.1 PRE-START CHECK LIST2.2 STARTING & OPERATION 2.2.1. ENGINE & BLADE 2.2.3. PROPELLING MOWER TO REMOVE RECYCLING COVER 2.7 INSTALLATION OF SIDE DISCHARGE DEFLECTOR2.6 RECYCLING OPERATION Continued Next PageBOLT WITH REPLACEMENTROUTE RECOIL ROPE AROUND PULLEY SECURE ADAPTER TO DECK THREAD SLEEVE1. Grasp bag connector and bag handle as shown. See Figure Section 3 - MAINTENANCE IMPORTANT Drain fuel tank before tipping mower Section 4 - REPAIR & ADJUSTMENTS 4. Sharpen blade on a grinding wheel at an angle of 1. Grease on drive disc causing slippage 7. Reinstall driven disc spring to driven disc assembly MACHINE BEARINGREMOVE FOUR SCREWSTo replace the bearing on the pulley end of the hex Remove the driven disc. Refer to Section PROBABLE CAUSE TROUBLESHOOTINGPROBLEM CORRECTIVE ACTIONSERVICE SCHEDULE MAINTENANCE PARTS2 YEAR LIMITED WARRANTY PRIMARY MAINTENANCE PRIMARY MAINTENANCE PRIMARY MAINTENANCE PRIMARY MAINTENANCE SNAPPER PRODUCT REGISTRATION FORM Page Page Page Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and critical safety warnings. Read, Understand, and Follow all warnings and instructions in this manual, the engine manual, and on the machine, engine and attachments. If you have any questions about your Snapper product, contact your local authorized Snapper dealer or contact Snapper Customer Service at Snapper, McDonough, GA. 30253. Phone