Section 3 – MAINTENANCE
3.1INTRODUCTION
To retain the quality of the mower, use genuine SNAPPER replacement parts only. Contact a local SNAPPER dealer for parts and service assistance. For the correct part or information for a particular mower, always mention model and serial number.
WARNING
DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.
3.2SERVICE - AFTER FIRST 5 HOURS 3.2.1. CHANGE ENGINE OIL
1.Refer to Engine Manual for proper oil specifications, procedures and proper service intervals.
2.On Kawasaki engines, the oil drain plug is located in a spot that will prove both inconvenient and messy for draining oil. For simplest/cleanest oil change, simply tip mower on its side. See Figure 3.1. Drain oil through dipstick tube into a container. Allow sufficient time for all oil to drain.
IMPORTANT: Drain fuel tank before tipping machine. DO NOT tip machine with carburetor or spark plug down. Oil from crankcase will saturate the air filter and cause the engine to be hard to start or not start at all. If contamination does occur, the air filter will have to be replaced.
REMOVE OIL CAP
TIP MOWER TOWARD
RIGHT REAR
NOTE: Check specific model engine owner’s manual for changing engine oil procedure and oil specifications.
3.2.2.CHECK GREASE LEVEL IN TRANSMISSION 1. Remove transmission fill plug. Roll machine forward or backward while looking down into plug hole.
2. If liquid grease IS NOT visible on the input gear (the small gear below the plug hole), add an amount, to cover gear, of Snapper “00” grease. See Figure 3.2.
FILL PLUG
FIGURE 3.2
NOTE: Snapper “00” Grease (Part No. 7029443) is available at your SNAPPER dealer.
NOTE: Do not spill grease or oil on surface of drive disc. See Figure 3.4.
3.Reinstall transmission plug.
4.Check grease level after each 25 hours of operation.
KEEP DRIVE DISC CLEAN !
| FIGURE 3.1 |
| |
3. | Dispose of drain oil properly. |
| |
4. | Fill engine with oil as specified in Engine Manual. | FIGURE 3.4 | |
Do Not overfill. | |||
| |||
12