Snapper ZT20501BV, ZT19441KWV Check Tire Pressures, Checking / Adding Fuel, Fuel Filter

Regular Maintenance

CHECK TIRE PRESSURES

Tire pressure should be checked periodically, and main- tained at the levels shown in the chart. Note that these pressures may differ slightly from the “Max Inflation” stamped on the side-wall of the tires. The pressures shown provide proper traction, improve cut quality, and extend tire life.

CHECKING / ADDING FUEL

To add fuel:

1.Remove the fuel cap (see A, Figure 18).

2.Fill the tank to the bottom of the filler neck. This will allow for fuel expansion.

NOTE: Do not overfill. Refer to your engine manual for specific fuel recommendations.

3. Install and hand tighten the fuel cap.

FUEL FILTER

The fuel filter is located in the fuel line between fuel tank and fuel pump. If the filter is dirty or clogged, replace as follows:

1.Disconnect the negative battery cable.

2.Place a container below the filter to catch spilled fuel.

3.Using a pliers, open and slide hose clamps from fuel filter (C, Figure 18).

4.Remove hoses from filter.

5.Install new filter in proper flow direction in fuel line.

6.Secure with hose clamps.

Tire	Pressure
Front	40 psi (2,76 bar)
Rear	15 psi (1,03 bar)

Figure 17. Checking Tire Pressure

WARNING

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.

Do not remove fuel filter when engine is hot, as spilled gasoline may ignite. DO NOT spread hose clamps further than necessary. Ensure clamps grip hoses firmly over filter after installation.

Do not use gasoline containing METHANOL, gasohol containing more than 10% ethanol, gasoline additives, premium gasoline, or white gas because engine/fuel system damage could result.

7. Reconnect the negative battery cable when finished.

ENGINE MAINTENANCE

Refer to engine owners manual for all engine mainte- nance procedures and recommendations.

CHECK /FILL TRANSMISSION OIL

Oil Type: Mobil 1™ 15W-50 synthetic oil, Castrol Syntec™ 5W-50 oil, or 20W-50 conventional detergent motor oil.

1.Check the oil level when the unit is cold. The inspec- tion port is located on the inside of the right tank cover. The oil level should be within 1/2” (1.3 cm) of the horizontal level mark (D, Figure 19). If the oil is below this level, proceed to step 2.

2.Before removing the reservoir cap, make sure the area around the reservoir cap and fill neck of the reservoir is free of dust, dirt, or other debris. Loosen the locking capscrew (E, Figure 18) securing the lock- ing tab (D), slide the lock tab back, and remove the cap (B).

3.Add oil up to the full mark (D, Figure 19).

B

A

B

D

E

C

Figure 18. Maintenance

A.Fuel Tank Cap

B.Transmission Oil Cap

C.Fuel Filter

D.Locking Tab

E.Locking Screw

17