SECTION 5: ENGINE MAINTENANCE
WARNING: Use care when servicing any component in the engine area. If the engine has recently been operated, components will be hot and could cause burns. Allow the engine to cool before servicing.
WARNING: Before servicing the engine, place the tractor on a level surface, stop the engine, engage the parking brake, and remove the key from the ignition switch.
CLEANING THE ENGINE
This tractor has a
WARNING: Keep the muffler area clean. Before running the engine, remove all combustible debris from the muffler area.
CLEANING RADIATOR/RADIATOR SCREEN
To remove the radiator screen, lift the hood and care- fully lift screen by the center tab. Flush the screen with water to clean its surface. See Figure 50.
RADIATOR SCREEN
RADIATOR CAP
TRANSMISSION |
|
|
| RADIATOR |
OIL COOLER |
|
|
| |
|
|
|
|
Figure 50
Check the radiator and transmission cooler fins for any accumulation of debris lodged between cooling fins. Blow the debris out using compressed air directed from the fan shroud side of the radiator.
Reinsert the screen, making sure that it is in the slots of the radiator frame.
CHECKING ENGINE OIL LEVEL
Before each use, the oil level in the engine crankcase should be checked to see that it is filled to the correct level. During the "break in" period for the engine, closely monitor the engine oil level. The oil level should be checked hourly during the first 5 hours of operation.
•Check the oil level only while the engine is stopped and the tractor is level. Clean the area around the oil level dipstick to prevent debris from entering the crankcase. See Figure 51.
•If recently operated, allow the engine to cool and the oil to drain back into the oil pan.
•To check the oil level, withdraw the dipstick and wipe it clean. Reinsert the dipstick all the way into the tube before withdrawing it for a true reading.
DIPSTICK
DIPSTICK
TUBE
Figure 51
•Always keep the oil level between the full and the add marks on the dipstick. See Figure 52.
•Reinsert the dipstick into the dipstick tube and push firmly into the tube.
DIPSTICK
ADD MARK | FULL MARK |
Figure 52
40