Cub Cadet 6284 manual Accessing the Engine Compartment, General Battery Information

Page 30

ACCESSING THE ENGINE COMPARTMENT

WARNING: If the tractor has been recently operated, engine surfaces (including the radiator) will be HOT. Allow the engine to cool before open- ing the hood, or use extreme caution to avoid burns when the hood is open.

To raise the hood, locate the latch release lever in the hood notch at the front of the tractor. Lift and hold the latch release lever while lifting the hood at the hood notch. See Figure 34.

•Fully raise the hood so that the hood prop cylinders hold the hood in the raised position.

HOOD

NOTCH

Lift Hood

LATCH

 

RELEASE

Lift Lever

LEVER

 

Figure 34

To remove the two side panels:

•Flip the tabs of the two quick release fasteners up and turn to align with the slots in the side panel. See Figure 35.

•Pivot the top of the side panel over and off the quick fastener tabs.

•Pivot the top of the side panel until the two tabs at the bottom of the panel can be withdrawn from the slots of the side panel mounting brack- ets; then remove the side panel. See Figure 35.

To reinstall the side panels:

•Insert the two side panel tabs into the slots of the side panel mounting brackets. See Figure 35.

•Pivot the top of the panel toward the tractor and over the tabs of the quick release fasteners.

•Pull the quick fastener tabs slightly outward and rotate 1/4 turn (perpendicular to slot) to lock the side panels in place. Flip the fastener tabs down.

QUICK FASTENER

Pivot

Flip up

Turn

QUICK

FASTENER

SIDE

PANEL

SIDE PANEL

TABS IN MTG.

BRKT. SLOTS

Figure 35

Close the hood by pushing downward until captured by the hood latch.

GENERAL BATTERY INFORMATION

WARNING:

•Battery posts, terminals and related accesso- ries contain lead and lead compounds. Wash hands after handling.

•Should battery acid accidentally splatter into the eyes or onto the skin, rinse the affected area immediately with clean cold water. If there is any further discomfort, seek prompt medical attention.

•If acid spills on clothing, first dilute it with clean water, then neutralize with a solution of ammonia/water or baking soda/water.

•NEVER connect (or disconnect) battery charger clips to the battery while the charger is turned on, as it can cause sparks.

•Keep all sources of ignition (cigarettes, matches, lighters) away from the battery. The hydrogen gas generated during charging can be combustible.

•As a further precaution, only charge the battery in a well ventilated area.

•Always shield eyes and protect skin and clothing when working near batteries.

WARNING: Batteries contain sulfuric acid and may emit explosive gases. Use extreme caution when handling batteries. Keep batteries out of the reach of children.

30

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Important Read Safety Rules and Instructions Carefully Operator’s ManualTable of Contents Calling Service InformationTo the Owner Recording Model and Serial Number Information Tractor Model PlateRops Information Plate Important Safe Operation Practices General OperationSlope Operation Do notSafety Frame Rops Warni NG Safety Labels Controls and Features Floorboard and Dash Panel Mounted ControlsSeat Adjustment Lever PTO SwitchIgnition Switch Steering WheelDifferential Lock Pedal Hazard Light SwitchHeadlight Switch Parking Brake LeverPTO Engaged Indicator Battery Indicator LightOil Pressure Indicator Brake Engaged IndicatorFuel Fill Cap Fender Mounted Conrtols and FeaturesPTO Reverse Override Switch PTO Selection LeverHand Holds Transmission Hi/Lo Range Shift LeverCup Holder Amber Hazard LightsOperation Rollover Protective Structure RopsFolding the Rops Safety Interlock System NEW Tractor BREAK-IN ProceduresFueling the Tractor Cold Weather Starting Using Jumper Cables to Start EngineStarting the Engine Stopping the EngineDriving on Slopes Using the FORWARD/REVERSE PedalDriving the Tractor Stopping the TractorUsing the HI/LO Range Shift Lever Using the Differential Lock PedalLOW Using the Hydraulic Lift Lever Using the PTO Selection LeverEngaging the PTO Hazard Lights Using the PTO Reverse Override SwitchUsing the TOP Link Retainer Hook LightingUsing the Hitch Plate Using the Three Point HitchUsing the Auxiliary Hydraulic Valve Using the Auxiliary Hydraulic Control HandleTractor Weighting On Demand Four Wheel DriveAdjusting the Seat Belt AdjustmentsAdjusting the Seat Three Point Hitch AdjustmentsAdjusting Front Wheel TOE-IN Check the TOE-IN AS FollowsAdjusting the Brakes Adjusting Hydraulic Lift Feedback RODMaintenance General InformationLubrication and Maintenance Chart Illustration Lubrication and Maintenance Chart Accessing the Engine Compartment General Battery InformationBattery Maintenance Battery RemovalCharging the Battery Battery StorageHead Light Bulb Replacement Tail LIGHT/HAZARD Light Bulb ReplacementServicing Electrical System Electrical Circuit Relays Accessing the Lower Dash Panel AreaChecking/Replacing Fuses Right SideHazard Light Flasher Relay Checking TRANSMISSION/HYDRAULIC System OIL LevelInitial Break-In Period Filter Change Changing TRANSMISSION/HYDRAULIC System OILRegularly Scheduled Oil Filter Changes Check Front Axle OilCheck Final Reduction Gear Case Oil Changing Front Axle and Final Reduction Gear Case OILLubrication of Main Drive Shaft Maintenance of the Rollover Protective Structure RopsTire Maintenance Lubrication of FWD Drive ShaftTractor Storage Removing the Tractor from StorageCleaning the Engine Cleaning RADIATOR/RADIATOR ScreenChecking Engine OIL Level Adding Engine OIL Changing the Engine OIL and FilterChecking Engine Coolant Level Changing the AIR Cleaner Inspection of Cooling System HosesChanging the Engine Coolant Servicing the Fuel Filter Draining The Fuel FilterChanging The Fuel Filter Engine Breather Service Fuel Injector Nozzle ServiceSpecifications Hydraulic Lift System Power Take-OffGeneral Dimensions BrakesOptional Equipment and Accessories Description Model NumberPage Page Page CUB Cadet LLC Post Office BOX CLEVELAND, Ohio

6284 specifications

The Cub Cadet 6284 is a robust utility tractor known for its versatility and reliability. Designed for both residential and commercial use, it is ideal for tasks such as landscaping, gardening, and light agricultural work. This model stands out in the compact tractor market due to its powerful engine and innovative features that boost productivity and ease of use.

At the heart of the Cub Cadet 6284 lies a powerful 28-horsepower Kohler diesel engine, which provides ample torque for demanding applications. This engine is designed for efficiency and durability, ensuring long-lasting performance and reduced operating costs. The liquid-cooled design helps to maintain optimal operating temperatures, extended engine life, and consistent power output, making it suitable for various weather conditions.

One of the key characteristics of the 6284 is its hydrostatic transmission, which offers seamless shifting without the need for clutching. This feature allows operators to maintain a steady pace while maneuvering in tight spaces or during intricate tasks. The intuitive controls enhance user experience, making it an excellent choice for both seasoned operators and newcomers alike.

The 6284 features a heavy-duty, rear-mounted three-point hitch with a standard lift capacity which enables the attachment of various implements, enhancing its versatility. With a variety of compatible attachments, including rotary cutters, plows, and loaders, users can easily switch between tasks, making it a multifunctional workhorse.

Another notable technology integrated into the Cub Cadet 6284 is the ergonomic operator station. The layout is designed with user comfort in mind, featuring an adjustable seat, easy-to-reach controls, and excellent visibility, allowing operators to work efficiently for extended periods. The compact design aids in maneuverability, especially in more confined spaces.

Additionally, the Cub Cadet 6284 is built with a sturdy frame and quality materials, designed to withstand heavy use. The all-steel construction contributes to its overall durability, ensuring that the tractor can handle tough jobs without compromising performance.

In summary, the Cub Cadet 6284 is a powerful and efficient compact utility tractor that offers reliable performance for a variety of tasks. Its combination of a robust engine, hydrostatic transmission, and ergonomic design makes it a valuable addition to any toolkit. Whether for residential gardening or more extensive commercial applications, the 6284 is equipped to tackle the job with ease and efficiency.
Top Page Image Contents