Cub Cadet 6284 manual Checking/Replacing Fuses, Accessing the Lower Dash Panel Area, Right Side

Page 33

Checking/Replacing Fuses

The main fuse in the tractor wire harness protects the tractor’s entire electrical system. A blown main fuse will prevent battery current from passing though the harness. If all the tractor’s electrical functions are disable, check the main fuse.

The timer fuse protects the glow plug timer from amperage spikes. If the glow plug timer does not operate check the timer fuse.

To access the fuses, proceed as follows:

•Raise the tractor hood and remove the right side panel.

•Locate the appropriate fuse holder on the front of the bulkhead, just inside the right side of the dash panel. See Figure 40.

GLOW PLUG

 

 

 

 

 

 

 

TIMER

 

 

 

 

 

 

MAIN FUSE

 

 

 

 

 

TIMER

 

 

 

 

 

 

 

 

 

FUSE HOLDER

FUSE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WIRE

 

 

 

 

 

 

 

 

 

HARNESS

DASH

 

 

 

 

GLOW PLUG

 

 

 

 

 

 

 

 

 

 

 

 

RELAY

PANEL

 

 

 

 

 

 

 

Figure 40

•Pull the fuse from the fuse holder, check the fuse per Figure 39 and, if necessary, replace with the same capacity fuse — 30 amps for the main fuse and 5 amps for the timer fuse. Never use a higher amperage fuse.

•Install the side panel and lower tractor hood.

Accessing the Lower Dash Panel Area

Some electrical components are housed inside the lower dash panel. To access the area, remove the dash panel insert by removing the two screws. See Figure 41.

SCREWS

DASH

PANEL

INSERT

Figure 41

To reinstall the dash panel insert, hook the retaining lip at the bottom of the insert over the bottom edge of the dash opening, pivot the insert upward into position, and secure with the two screws.

Electrical Circuit Relays

Several relays which control electrical functions of the tractor are located inside the lower dash panel. If one of the circuits is not functioning properly, have your dealer electrically check the relay. See Figure 42.

•Start Relay — This relay functions in the start circuit to activate the starter motor.

•PTO Relay — This relay operates in conjunc- tion with both the Reverse Relay and Reverse Override Relay to engage the PTO.

•Reverse Relay — This relay functions with the PTO relay and Reverse Switch in the "No Cut in Reverse" circuit.

•Reverse Override Relay — This relay functions with Reverse Override Switch and PTO Relay to maintain PTO engagement when driving in reverse.

•Cruise Control Relay — This relay is installed at the factory for use with the optional Cruise Control Kit. The relay functions in the cruise control circuit, when the kit is installed.

START

Right Side

 

RELAY

 

PTO

 

RELAY

 

Left Side

CRUISE

CONTROL

 

RELAY

 

(OPTIONAL)

 

REVERSE

 

OVERRIDE

 

RELAY

 

REVERSE

 

RELAY

Figure 42

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Operator’s Manual Important Read Safety Rules and Instructions CarefullyTable of Contents Calling Service InformationTo the Owner Recording Model and Serial Number Information Tractor Model PlateRops Information Plate General Operation Important Safe Operation PracticesDo not Slope OperationSafety Frame Rops Warni NG Safety Labels Floorboard and Dash Panel Mounted Controls Controls and FeaturesIgnition Switch PTO SwitchSeat Adjustment Lever Steering WheelHeadlight Switch Hazard Light SwitchDifferential Lock Pedal Parking Brake LeverOil Pressure Indicator Battery Indicator LightPTO Engaged Indicator Brake Engaged IndicatorPTO Reverse Override Switch Fender Mounted Conrtols and FeaturesFuel Fill Cap PTO Selection LeverCup Holder Transmission Hi/Lo Range Shift LeverHand Holds Amber Hazard LightsOperation Rollover Protective Structure RopsFolding the Rops Safety Interlock System NEW Tractor BREAK-IN ProceduresFueling the Tractor Starting the Engine Using Jumper Cables to Start EngineCold Weather Starting Stopping the EngineDriving the Tractor Using the FORWARD/REVERSE PedalDriving on Slopes Stopping the TractorUsing the HI/LO Range Shift Lever Using the Differential Lock PedalLOW Using the Hydraulic Lift Lever Using the PTO Selection LeverEngaging the PTO Using the TOP Link Retainer Hook Using the PTO Reverse Override SwitchHazard Lights LightingUsing the Auxiliary Hydraulic Valve Using the Three Point HitchUsing the Hitch Plate Using the Auxiliary Hydraulic Control HandleOn Demand Four Wheel Drive Tractor WeightingAdjusting the Seat AdjustmentsAdjusting the Seat Belt Three Point Hitch AdjustmentsCheck the TOE-IN AS Follows Adjusting Front Wheel TOE-INAdjusting Hydraulic Lift Feedback ROD Adjusting the BrakesGeneral Information MaintenanceLubrication and Maintenance Chart Illustration Lubrication and Maintenance Chart General Battery Information Accessing the Engine CompartmentCharging the Battery Battery RemovalBattery Maintenance Battery StorageHead Light Bulb Replacement Tail LIGHT/HAZARD Light Bulb ReplacementServicing Electrical System Checking/Replacing Fuses Accessing the Lower Dash Panel AreaElectrical Circuit Relays Right SideChecking TRANSMISSION/HYDRAULIC System OIL Level Hazard Light Flasher RelayChanging TRANSMISSION/HYDRAULIC System OIL Initial Break-In Period Filter ChangeCheck Front Axle Oil Regularly Scheduled Oil Filter ChangesChanging Front Axle and Final Reduction Gear Case OIL Check Final Reduction Gear Case OilTire Maintenance Maintenance of the Rollover Protective Structure RopsLubrication of Main Drive Shaft Lubrication of FWD Drive ShaftRemoving the Tractor from Storage Tractor StorageCleaning the Engine Cleaning RADIATOR/RADIATOR ScreenChecking Engine OIL Level Changing the Engine OIL and Filter Adding Engine OILChecking Engine Coolant Level Changing the AIR Cleaner Inspection of Cooling System HosesChanging the Engine Coolant Servicing the Fuel Filter Draining The Fuel FilterChanging The Fuel Filter Fuel Injector Nozzle Service Engine Breather ServiceSpecifications General Dimensions Power Take-OffHydraulic Lift System BrakesDescription Model Number Optional Equipment and AccessoriesPage Page Page CLEVELAND, Ohio CUB Cadet LLC Post Office BOX

6284 specifications

The Cub Cadet 6284 is a robust utility tractor known for its versatility and reliability. Designed for both residential and commercial use, it is ideal for tasks such as landscaping, gardening, and light agricultural work. This model stands out in the compact tractor market due to its powerful engine and innovative features that boost productivity and ease of use.

At the heart of the Cub Cadet 6284 lies a powerful 28-horsepower Kohler diesel engine, which provides ample torque for demanding applications. This engine is designed for efficiency and durability, ensuring long-lasting performance and reduced operating costs. The liquid-cooled design helps to maintain optimal operating temperatures, extended engine life, and consistent power output, making it suitable for various weather conditions.

One of the key characteristics of the 6284 is its hydrostatic transmission, which offers seamless shifting without the need for clutching. This feature allows operators to maintain a steady pace while maneuvering in tight spaces or during intricate tasks. The intuitive controls enhance user experience, making it an excellent choice for both seasoned operators and newcomers alike.

The 6284 features a heavy-duty, rear-mounted three-point hitch with a standard lift capacity which enables the attachment of various implements, enhancing its versatility. With a variety of compatible attachments, including rotary cutters, plows, and loaders, users can easily switch between tasks, making it a multifunctional workhorse.

Another notable technology integrated into the Cub Cadet 6284 is the ergonomic operator station. The layout is designed with user comfort in mind, featuring an adjustable seat, easy-to-reach controls, and excellent visibility, allowing operators to work efficiently for extended periods. The compact design aids in maneuverability, especially in more confined spaces.

Additionally, the Cub Cadet 6284 is built with a sturdy frame and quality materials, designed to withstand heavy use. The all-steel construction contributes to its overall durability, ensuring that the tractor can handle tough jobs without compromising performance.

In summary, the Cub Cadet 6284 is a powerful and efficient compact utility tractor that offers reliable performance for a variety of tasks. Its combination of a robust engine, hydrostatic transmission, and ergonomic design makes it a valuable addition to any toolkit. Whether for residential gardening or more extensive commercial applications, the 6284 is equipped to tackle the job with ease and efficiency.
Top Page Image Contents